Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A differential amplifier has a difference signal of 3.25 mV. The noise signal is measured to be 1.35 V. The output difference signal is 3.95 V and the common-mode output signal is0.95 mV. Determine the common-mode gain, the differential mode gain, the CMRR, and the CMR (in dB) for the amplifier.
If a frame is damaged then in this network the receiver sends back a request for retransmission. (For simplicity, assume all these requests arrive back perfectly at the sender). What is the mean number of transmissions required to successfully tra..
Four frequencies are applied at the input of anon-linear amplifier. Write down all of the frequency components at the output of the non-linear device. Write down only the first three harmonics find out the frequency components at the output
A 6th order Chebyshev low pass filter has a 0.5dB ripple in the pass-band and has a cutoff frequency of 5Khz, determine the attenuation (dB) of the signal at: 1. 4Khz 2. 40Khz 3. 40Mhz
The system works as follows. When the main program starts to run, the microprocessor commands the A/D to convert. The microprocessor then sits in a dummy loop until the A/D interrupts, after it has completed the conversion and data is available.
Determine the eigenvalues of the system: y1'=8y1-y2 y'2=y1+10y2 What is the stability of the critical point lambda(base)1=2+i2, lambda=2-i2, Stable and attractive
A single-phase circuit is placed across a 120-V rm, 60-Hz source, with an ammeter, a voltmeter, and a wattmeter connected. The instrucments indicate 12 A, 120 V, and 800 W, resppectively. Find (a) the power factor, (b) the phase angle
120V, 60 Hz source is connected to a distribution line whose resistance, and inductive reactances are 0.1Ohm, j0.2 Ohm, respectively. Single phase, 2HP, 120V, 0.75 lagging pf. motor and 2.4Kw, 120V heater is connected in parallel.
a). If the 8th bit is set to0, what is the minimum Hamming distance between the 8-bit ASCII character code words b). If the 8th bit is usedfor parity, what is the minimum Hamming distance between the 8-bitASCII character code words
What is the maximum number of DECIMAL digits that can be generated with this choice of N (ie. the maximum length of the sequence of decimal numbers that could be generated with this choice of N, before any number repeats itself)
Find the electric field intensity at (0,0,75000) produced by 50,000 0.1 C charges along the x-axis spaced at 1 meter apart starting at (1,0,0) and 50,000 0.2 C chargers along the y-axis spaced at 1 meter apart starting at (0,1,0).
In a certain system, an electrical heating element was found to increase the temperature of a piece of metal 7o for each amp of current. The metal expands 0.004 in./deg and pushes on a load sensor that outputs 1 V/0.003 in.
An amplifier operates from -5V and +5V balanced power supplies. It provides a 3.2-Vpeak sine across a 150 ohm load when provided with a 0.2-V peak input from which 2.0mA peak is drawn. The average current in each supply is 20mA.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd