Determine the coil current and the energy stored in steel

Assignment Help Electrical Engineering
Reference no: EM13286462

The entire device is made of sheet steel. The coil has 2,000 turns. The armature is stationary so that the length of the air gaps, g=10mm, is fixed. A direct current passing through the coil produces flux density of 1.2 T in the gaps. assumeπr=4,000 for sheet steel. Determine
a. The coil current.
b. The energy stored in the air gaps.
c. the energy stored in the steel.

Reference no: EM13286462

Questions Cloud

What is voltage required to get classical music station : The p-n junction in part (a) is used as a capacitor in an LC circuit to tune two WHRO stations in your car radio. When no voltage is applied a radio station transmitting at 89.5 MHz is received. What is the voltage required to get the classical mu..
Explain the entire system to warm to room : If we inject 120.0 mL of liquid helium and allow the entire system to warm to room temperature (25°C), what is the pressure inside the bottle
What single investment made today : Answer each of the following questions. a. What single investment made today, earning 12% annual interest, will be worth $ 6,000 at the end of 6 years?
What is the total duration of the rockets flight : A model rocket blasts off and moves upward with an acceleration of 15m/s^2 until it reaches a height of 35m, what is the total duration of the rocket's flight
Determine the coil current and the energy stored in steel : The armature is stationary so that the length of the air gaps, g=10mm, is fixed. A direct current passing through the coil produces flux density of 1.2 T in the gaps. assumeπr=4,000 for sheet steel. Determine a. The coil current.
What is the repayment at the end of year 4 : A person borrows $200 to be repaid in 8 years with 14% annually compounded interest. The loan may be repaid at the end of any earlier year with no prepayment penalty.
Evaluate the activation energy ea for the reaction : A first order chemical reaction has a rate constant of 5.8×104 s-1 at 10 °C and a rate constant of 4.7×105 s-1 at 64 °C. Calculate the activation energy, Ea, for the reaction.
Estimate of the intrinsic value : If a stock's market price exceeds its intrinsic value as seen by the marginal investor, the the investor will sell the stock until its price has fallen down to the level of the investor's estimate of the intrinsic value.
Determine the electric flux through the wall : A vertical wall (7.2 m 2.8 m) in a house faces due east. A uniform electric field has a magnitude of 150 N/C. What is the electric flux through the wall

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the input sequence of voltage

in a balanced three-phase wye system the source is an abc-sequence set of voltage. the load voltage on the a phase is Van= 108.58

  Find maximum value that angle can reach during the fault

A three-phase fault occurs at the generator terminals causing the angle of part (c) to increase. The fault is subsequently cleared. Find the maximum value that this angle can reach during the fault (i.e. the critical clearing angle) so that the ge..

  How to connect a dmm that is set up to measure current

1-why placement of grounds is significant to obtaining accurate measurements when using instruments that can be grounded, such as scopes and 2) why should we never connect a DMM that is set up to measure current across a voltage supply

  What is the maximum bit rate that can be transmitted

Binary data is transmitted through an Additive White Gaussian Noise (AWGN) channel with SNR=3.5 dB and bandwidth B. Channel coding is used to ensure reliable communications. Then: i. What is the maximum bit rate that can be transmitted

  Why has lead-free solder replaced lead-based solder

What is the purpose of core in hollow solder wire What is tinning, and why is it important Why is safety so important when soldering Why has lead-free solder replaced lead-based solder

  Write software to spin the motor at 1 rps

Design an interface for a 12 V, 500 mA bipolar stepper motor. There are 200 steps per revolution. Write software to spin the motor at 1 rps.

  A three-phase system over a single-phase system

Give three advantages of a three-phase system over a single-phase system There are two basic three-phase connections, the wye connection and the delta connection. Draw a labelled diagram showing the wye connection

  Show the mapping in terms of tag-index and block offset

Main Memory size is 256K words, Cache size is 16K words block size is 32 bytes Show the mapping in terms of tag, index and block offset for direct map, 4 way set associative, fully associative

  Determine how many different layouts are possible

(a) If five different types of chips are to be placed on the board, how many different layouts are possible (b) If the five chips that are placed on the board are of the same type, how many different layouts are possible

  Determine the turns ratio for the transformer

The amplifier has a Thévenin voltage of 25[Vrms], and a Thévenin resistance of 0.275[O]. Find the turns ratio for the transformer, so that the maximum possible power is delivered to the speaker.

  Derive the sensitivity for voltage and current source excite

1. Derive the sensitivity for a voltage and current source excited Wheatstone bridge. 2. Show the balance condition for a Wheatstone bridge is also true in the sinusoidal steady state if the resistances are replaced with complex impedances.

  How the signals were changed to a power level

A typical method of measuring the linearity of an amplifier is called the "Two-tone" test. Signals at f1 and f2 are input to the amplifier and the output spectrum is observed. Assuming that signals at 14.1 and 14.2 MHz are input to an amplifier.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd