Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Determine the capacitive reactance in ohm miles for the line of Problem 5.7. Assume the conductor's outside diameter is 1.6 in. Repeat by including earth effects given that the ground clearance is 90 ft.
Problem 5.7
Repeat Problem 5.6 for bundle spacing of 24 in. and subconductor GMR of 0.05 15 ft. Assume phase separation is 45 ft.
Problem 5.6
Find the inductive reactance in ohms/mile/phase for the 765-kV, single-circuit, bundle-conductor line with four subconductors per bundle at a spacing of 18 in., given that the subconductor GMR is 0.0385 fi. Assume horizontal phase configuration with 44.5-ft phase separation.
The torque T causes a rotation of 0.68 at end B of the aluminum bar shown. Knowing that b = 15 mm and G = 26 GPa, determine the maximum shearing stress in the bar.
A nickel-iron ring withcross-sectional area 0.85cm2 is expected to be driven to itssatur-ation magnetization of 1.1T in a ?eld of 800 A/m. The ?ux density will be measured by an electronic ?ux integrator with input resistance of 1kOhm
what are the octal values of the four 8-bit bytes in the 32-bit number with octal representation 321076543218
The 300-kg block is acted upon by a force P, pulling it as shown. P makes an angle of 36o with the horizontal. If the coefficient of sliding friction between the block and the floor is 0.35, determine the force required to start moving the block.
For each of the following application: A) Wireless home AC remote.B) Nuclear Power plant monitoring system.
Using Kirchhoff's current law, determine the unknown currents for the networks of given figure:
(a) Find Cox and (b) For an NMOS transistor with W/L = 15 m/0.25 m, calculate the values of VOV , VGS, and VDSmin needed to operate the transistor in the saturation region with a dc current ID= 0.8mA.
how could an oscilloscope be used to display current waveforms instead of voltage waveforms. what constraints apply to your current measuring method.
To meet the signal-to-noise ratio of the receiver, the received power must be at least 10 µ W. Assuming the two antennas are aligned for maximum reception to each other, including being polarization matched, what should the gain (in dB) of the tra..
Find the impulse response and transfer function of a filter matched to a triangular waveform as shown in the accompanying figure.
A 12-bit ADC with a Vref of 5V is used to digitize small signals with a quiescent value of 2.5V and a variation around 2.5 of +/- 100mV. What is the SNR of the digitized signal if the ADC is ideal
Find the Fourier Transform of f(t),Plot (with axis labels) the frequency spectrum for the continuous signal. (both magnitude and phase)What is the bandwidth of this signal in rad/s and Hz?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd