Determine the air exit temperature

Assignment Help Mechanical Engineering
Reference no: EM13707438

Air with a mass flow rate of 1.5 kg/sec and temperature of 400 K flows through a horizontal duct of an air heater. If 36 kJ/sec of heat is added to the flow, determine the air exit temperature. Assume ideal gas and neglect any change in pressure and velocity

Reference no: EM13707438

Questions Cloud

Determine how long it will take to vaporize all of liquid : A closed rigid, well-insulated tank contains 2 kg of saturated mixture of water at 159kPa. Initially, three-quarters of the mass in the tank is saturated liquid. An electric resistance heater placed in the tank is connected to a 11-V source and curre..
Determine the quality of the wet stream : Wet stream (Saturated liquid-vapor mixture) at 2.00 Mpa is the initial state of a constant enthalpy process. The end state is at 0.100 Mpa, 150?. Determine the quality of the wet stream (i.e. the initial state)
Stresses at a point in plane stress on the body : The stresses at a point in plane stress on the body of a car were found to be sigma_xx = 30 MPa (C), sigma_yy = 60 MPa (T) and Tau_xy = 40 Mpausing matrix methods a) determine the normal and shear stresses on a plane passing through the point that is..
Describe how the hereditary information contained in genes : Describe how the hereditary information contained in genes within the cell’s DNA is expressed as proteins that direct the cell’s activities.  3.19 Trace the path of a single red blood cell from a capillary bed in your right hand to the capillary beds..
Determine the air exit temperature : Air with a mass flow rate of 1.5 kg/sec and temperature of 400 K flows through a horizontal duct of an air heater. If 36 kJ/sec of heat is added to the flow, determine the air exit temperature. Assume ideal gas and neglect any change in pressure and ..
Determine the thrust of the rocket : Consider a rocket engine with an exit area of 8.5 m2. The flow rate of fuel and oxidizer are 75 kg/sec and 8 kg/sec respectively. Determine the thrust of the rocket if it is operating at an altitude of 200 km above sea level. The exhaust velocity and..
Containers arrive at a stocking station on a conveyor : Containers arrive at a stocking station on a conveyor at the rate of five per minute. Container weight is 25 kg. Conveyor height is 50 inches and the stocking point is 70 inches above the ground. The stocking operation involves a twisting motion.
Constant-temperature expansion until the volume : One kg of air in a piston-cylinder assembly undergoes two processes in series from an initial state where p1 = 0.5 MPa, T1 = 227oC. Process 1-2: Constant-temperature expansion until the volume is twice the initial volume. Process 2-3: Constant-volume..
Write a report for your executive leader : Write a report for your executive leader that analyzes the predictable stages of virtual team development and offers recommendations, supporting your analyses and recommendations with resources from your research.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Estimate the speed of the body

A 15cm cube of mass 3kg is lubricated with SAE 10 oil at 20oC (dynamic viscosity of 0.104Ns/m2) slides down a 10o inclined plane at a constant velocity. Estimate the speed of the body if the oil film has a thickness of 2mm and the velocity distrib..

  During a cold day it is observed that the appliances all

a room contains 75 kg of air at 100 kpa and 15 deg c. the room has a 250 w refrigerator a 120 w television a 1.8 kw

  What is the biot number of this cooling situation would

an aluminum cube initially at 400oc with a dimension of 2 cm on each side is cooled using 30oc air with a convection

  An air-standard otto cycle has a compression ratio of 8 and

an air-standard otto cycle has a compression ratio of 8 and the temperature and pressure at the beginning of the

  The pressure difference between the large and small

a venturi meter is used to measure the water flow in a 3cm diameter pipe. the diameter of the narrow section is 1.5 cm.

  After the block is released from rest it travels upward and

a block of mass 0.256 kg is placed on top of a light vertical spring of force constant 4 925 nm and pushed downward so

  Find the minimum release height so that the car

a small toy car of mass 50 gm is released from rest at a height h to slide down a ramp into a vertical loop of diameter

  A paddle wheel within the cylinder is rotated until 15 kj

an insulated piston-cylinder device contains 100 l of air at 400 kpa and 25degc. a paddle wheel within the cylinder is

  A 3000-lb car accelerates under constant power from 60

a 3000-lb car accelerates under constant power from 60 mileh to 90 mileh on a 0.25 mile straight level test track.

  The chain and lever attached to the gate have negligible

a gate with a circular cross section is held close by a lever 1 m long attached to a buoyant cylinder. the cylinder is

  Pilot in an airplane flying horizontally with constant speed

A pilot in an airplane flying horizontally with constant speed of v = 480 km/hour at an elevation of h=610 m above a level plain wishes to bomb a target B on the ground as shown below. At what angle below the horizontal should he see the target at th..

  For a adiabatic steam turbine the operating conditions are

for a adiabatic steam turbine the operating conditions are as followsu1 2750 kjkgp1 3000 kpav1 0u2 2437.89 kjkgp2

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd