Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.2MW wind turbine has rotor diameter 64 m. Turbine operates in area with average wind veocity=7.5m/s with air density = 1.18kg / m^3. Turbine power coeff. including unit efficiency = 42.8 % Determine power output and the annual energy produced?
A 1.2 MW wind turbine has a rotor diameter of 64 m. the turbine operates in an area with an average wind velocity of 7.5 m/s and the air density of 1.18 kg/m^3. the turbine power coefficient including the unit efficiency is 42.8 percent.
Calculate the tetrahedral bond angle, the angle between any pair of the four bonds in a diamond lattice. (Hint: represent the four bonds as vectors of equal length. What must the sum of the four vectors equal
Supply the quantisation levels (including zero) that are available. Do this for both the three and 4-bit ADC in table form. What is the resolution of each quantizer?
If a frame is damaged then in this network the receiver sends back a request for retransmission. (For simplicity, assume all these requests arrive back perfectly at the sender). What is the mean number of transmissions required to successfully tra..
Calculate the inductive reactance per meter of a single-phase, 50-Hz, two-wire transmission line. Assume each conductor's radius is 3cm and the distance between the two conductors is 2m .
Compute the inverse Fourier transform for X(ω) = cos 4ω. 5. A signal with the highest frequency component at 10 kHz is to be sampled. To reconstruct the signal, the sampling must be done at a minimum frequency of?
A single-phase 50-KVA, 2400/240-volt, 60-Hz distribution transformer has a 1-ohm equivalent leakage reactance and a 5000-ohm magnetizing reactance referred to the high-voltage side. If rated voltage is applied to the high-voltage winding
A closed-loop system has a hold circuit and process as shown below. Determine G(z) when T = 1 and Gp(s) = 2 / (s + 2). A sampled-data system such as that presented in the above problem has a sampling period T = 0.05s
A shunt regulator utilizes a zener diode whose voltage is 5.1V at a current of 50 ma and whose incremental resistance is 8 ohms. The diode is fed from a supply of 12 V nominal voltage through a 220 ohm resistor
Discretization - How does the size of the differential charge elements influence your results Find E at the point (0, a/2, a), for this study. Devise a good way to represent your data to demonstrate the influence of discretization.
For each add instruction in this problem, assume that EAX contains the given contents before the instruction is executed, and give the contents of EAX as well as the values of the CF, OF, SF, and ZF flags after the instruction is executed.
A slotted line is used to measure the voltage maximums and voltage minimums on a transmission line with a characteristic impedance of 50 . The voltage maximum is measured as 7.5 V and the minimum is 5 V. The line is terminated with a purely resist..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd