Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Given: A permanent magnet DC motor has a machine constant, Kv = 0.5 V-s. The no-load torque is 1.0 Nm. Assume mechanical torque loss is a constant.
Find: Determine the mechanical power developed by the unloaded motor at 1250 rpm. Find the back EMF at 1250 rpm and the armature current.
If the machine is driven at a speed of 459rpm to act as a generator of real power, find the rotor current referred to the stator and the real and reactive power outputs of the induction machine.
Determine the maximum raw instantaneous data rate that can be provided to a single user in EDGE, assuming that a single time slot on a single GSM channel is available.
Consider the best possible heat engine working in air at 25°C. The engine continuously converts heat from a source at 300°C to work, and heat is continuously transferred into the engine at a rate of 100 kJ/s.
A doorbell is connected to a transformer whose primary contains 3000 turns and which is connected to 120 VAC. If the doorbell requirs 0.2 A at 10 V, find the number of turns necessary for the secondary winding and the current that flows in the pri..
PLC 2 In a motor control system, one master stop pushbutton (Stop) is available for stopping the operation at any time. If the temperature switch (TSW) is closed, pressing the red pushbutton (RedPB) will turn on both motors M1 and M2.
If a stepper motor has a step-angle of 7.5? , what digital input rate is required to produce a rotation of 10 rev/sec What will be the step-angle for a hybrid stepper motor with eight stator windings and ten rotor teeth
Write an asm HCS12 program to flash LEDs on a dragon+ board three times when SW5 is pressed with a 5 kHz frequency, and 50% duty cycle clock signal. Generate a clock signal with 5 kHz frequency, and 50% duty cycle.
In a vessel with a volume 3 m3 you put 0.03 m3 of liquid water and 2.97 m3 of water vapor so that the pressure is 101.33 kPa. Then you heat the system until all liquid water just evaporates. What is the pressure and temperature in the vessel at th..
The Karina Light Company manufactures inexpensive light-emitting diode (LED) bulbs whose estimated lifetime in normal distribution with a mean of 9000 hours and a standard deviation of 500 hours. Calculate the probability that the LED will fail wit..
For a state machine, suppose the propagation and contamination delays of the next state circuit are 20nsecs and 5nsec, respectively. For the registers to store the current state, the propagation delay, set-up time, and hold time are 4 nsec, 2nsec,..
A data transmission system uses 16-ary(16 levels) base band signaling. A.) determine the minimum BW of a noiseless channel to transmit at 12,000 bits/sec with zero ISI. B.) Explain what pulse shaping(channel shaping) would be required above and wh..
What is the total power density and total available current density between wavelength of 280 and 1240 nm for the AM0 and AM1.5 spectra. Assume each photon generates on electron-hole pair. You will need AM1.5 and AM1.0 spectra.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd