Determine magnetic flux density using mean radius of toroid

Assignment Help Electrical Engineering

Reference no: EM13229575

Assume the coil around the toroid is one single coil and extends all the way around. A toroid is like a donut with a circular cross section. The following characteristics are given: Toroid material = sheet steel, N = 250 turns Inner Radius = 20cm Outer Radius = 25cm I = 2.5 Amps Determine: (a) Magnetic flux density using the mean radius of the toroid. (b) Inductance of the coil, assuming the flux density is the same throughout as found in (a).

Reference no: EM13229575

Questions Cloud

Explain which metal hydroxide will precipitate first : If a 0.100 molar solution of NaOH is added to a solution containing 0.200 molar Ni2+, 0.200 molar Ce3+, and 0.200 molar Cu2+, which metal hydroxide will precipitate first?

Ohs solutions case study : Emma is an accounting graduate, Des has expertise in occupational health and safety (OHS) and Satish has an IT degree.

What is the value of the feedback resistor required : A temperature sensor covers a range of 0 to 70 degrees C with an output sensitivity of 2 mV/degree C. The sensor is input to an ADC with voltage range of 0 to 4V. What is the value of the feedback resistor required for an inverting amplifier circu..

Explain new procedure and measured by chromatography : Traces of toxic, man-made hexachlorohexanes in North Sea sediments were extracted by a known process and by a new procedure, and measured by chromatography.

Determine magnetic flux density using mean radius of toroid : Assume the coil around the toroid is one single coil and extends all the way around. A toroid is like a donut with a circular cross section. The following characteristics are given: Toroid material = sheet steel, N = 250 turns Inner Radius

State the percentage of an additive in gasoline was measured : The percentage of an additive in gasoline was measured six times with the following results: 0.14, 0.15, 0.16, 0.17, 0.20, 0.11%. Find the average and RSD and 90% confidence intervals for the percentage of the additive.

What value of resistors are required for the voltage divider : A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference

Describe target markets of each branded supermarket : Draw the layout of each store and if possible include photographs-make sure you indicate the brand on the diagram

Find a minimum two level circuit using and gate : Find a minimum two level circuit (corresponding to the sum of products expressions) using AND and one OR gate per function for each of the following sets of functions: f(a,b,c,d) =fm(1,3,5,8,9,10,13,14) g(a,b,c,d) =fm(4,5,6,7,10,13,14)

User Account

All Pages