Determine how many address pins does the dram have

Assignment Help Electrical Engineering
Reference no: EM13291110

A 1GB DRAM uses 4-bit data and has equal-length row and column addresses. How many address pins does the DRAM have?

Reference no: EM13291110

Questions Cloud

What minimum length must the ramp have : A runaway truck with failed brakes is moving with a speed of 130 km/h just before the driver steers up an emergency escape ramp inclined at 15 degrees above the horizontal
Find the collision diameter : For alpha particles of energy 7.68 MeV scattered from a platinum foil two microns thick, find the collision diameter
Explain what is the molar concentration of solution : A solution of H2SO4(aq) with a molal concentration of 3.22 m has a density of 1.183 g/mL. What is the molar concentration of this solution?
Which form of market efficiency is violated : If someone were able to earn greater than the average returns for the market on a consistent basis, which form of market efficiency is violated?
Determine how many address pins does the dram have : A 1GB DRAM uses 4-bit data and has equal-length row and column addresses. How many address pins does the DRAM have?
Explain the surrounding water in the calorimeter : In a calorimetry experiment, it was determined that a 92.0 gram piece of copper metal released 1860 J of heat to the surrounding water in the calorimeter (qcopper = ?1860 J).
Determine the power triangle for each of the impedances : A circuit consists of two impedances, Z1=20/_30 ,Z2=14.14/_-45 , in parallel, supplied by a sourcevoltage V=100/_60. Determine the power triangle for each of the impedances and for the source.
Calculate the frictional force acting on the block : A 3.00-kg block starts from rest at the top of a 33.0° incline and slides 2.00 m down the incline in 1.75 s. Find the frictional force acting on the block
Explain what is the heat change of water : A 10.0 gram piece of metal is placed in an insulated calorimeter containing 250.0 g of water initially at 20.0°C. If the final temperature of the mixture is 25.0°C, what is the heat change of water

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find input current and power factor at maximum torque

A 500 hp, three-phase, 2200 V, 60 HZ, 12-pole, Y-connected, wound-rotor induction motor has the following parameters: R1 = .225 ohm : R'2= .235 ohm Xeq = 1.43 ohm and Xm = 31.8 ohm and Rm = 780 ohm

  Design an fir digital lowpass filter using window technique

The signal x(t) consists of sum of two components, x1(t) and x2(t). The signal x(t) is bandlimited to 40 kHz, and it is sampled at a rate of 100 Khz to yield the sequence x(n). It is desired to suppress the signal x2(t) by passing the sequence x(n) t..

  Calculate the total current of a large room

A large room is illuminated by twenty 150-watt lamps and thirty 100-watt lamps. If the circuit voltage is 116, calculate the total current.

  What is the torque when the antenna gets to within 5 degrees

A proportional controller for a rotating antenna has a gain Kp of 5 in-oz/deg. The antenna was initially pointing due south, but was then commanded to point southeast. What is the torque when the antenna gets to within 5o

  Design a 3-bit synchronous counter that counts the sequence

Design a 3-bit synchronous counter that counts the sequence 7, 4, 2, 1, 6, 5, 7, ect. Use "don't-cares" for the "next states" of the unwanted states. Use a D flip flop for the most significant bit, a T flip flop for the middle bit, and a JK flip f..

  What two points associated with the load line

Discuss the steps required in calculating the collector-emitter voltage in a VDB circuit. Why does this circuit have a very stable Q point Discuss whether transistors being used as switching circuits should be biased in the active region.

  Explain why no hole is generated by the electron excitation

a) Explain why no hole is generated by the electron excitation involving a donor impurity atom. (b) Explain why no free electron is generated by the electron excitation involving an acceptor impurity atom.

  Determine what size of copper wire is required

The generator voltage is 120 V and the lamp voltage should be 110 V or more. Calculate the current drawn by each lamp if its voltage is 110 V and its power is 100 W. Calculate the current in the two-wire line. Calculate the maximum resistance of t..

  Determine what intermediate power settings are available

Two heating elements with resistance R1 and R2 are to beused that can be operated in parallel, seperately, or inseries. The highest power is to be 1280W, and the lowestpower is to be 240W. Draw a cicuit diagram.A) What are the values needed for R1 ..

  Determine exact resonance frequency if 1 of microstrip line

The relative dielectric constant of the printed circuit board (PCB) is 4 and the microstrip lines have a characteristic impedance of 80W. The length of the microstrip lines are 30mm and 45mm, respectively.

  Determine what is the resonant frequency of a series circuit

what is the resonant frequency of a series circuit consisting of a 100 pf capacitor, a 10 k ohm resistor, and a 1 mH inductor

  What is acceleration in the direction parallel to the slope

The Schussing skier is on 25° slope. His mass is 80 Kg. The Kinetic coefficient of friction between his skis and the snow is μs = 0.08 . His velocity is 9 m/s. a) What is his acceleration in the direction parallel to the slope

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd