Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Let x[k] be a time-domain sequence and X[r] be its DFT. (When written as vectors, unless stated otherwise, always assume the first entry in the vector is at k=0 or r=0, respectively.)
If x[k] = [5, 9, 6, 10]
What is X[r] for r=2?
Locate and specify an appropriate sensor if it is to operate at 120 vac as an input to a PLC. Create the ladder diagram program to accomplish the specified control.
What does the DAQ Assistant do How is it useful over the legacy acquisition methods What does FFT stand for and what does it do to a real-time signal Sketch the output of an FFT analysis performed on a 100 Hz sinewave signal at 1 V.
A person shuffling across a dry carpet can be approximately modeled as a charged 100-pF capacitance with one end grounded. If the person touches a grounded metallic object such as a water faucet, the capacitance is discharged
Using nodal analysis solve for the current and supemode used to solve this circuit is located between which two nodes?
The waveform output by the signal generator in part (b) is changed so that the rectangular pulses have the same width but no longer are periodic. They occur at random intervals of time. Explain in words how the display on the spectrum screen would..
An overhead line with an inductance of 1.33 mH/km and capacitance of 8.34 nF/km is connected to an underground cable with an inductance of 0.266 mH/km and capacitance of 166 nF/km.
Determine the left triceps muscle force (Ftri), elbow joint reaction force (Rj) required to hold this position along with any ground reaction forces (Rg) and/or reaction moments (Mg) in the hand. Show all necessary free body diagrams along with th..
The LM358 op amp can be a single or dual supply op-amp. This mean that it can operate with just a single supply i.e. + 5 volt or with dual supplies i.e. (+ and -) 5 volt supplies. With a inverting configuration with dual supplies (+5v and -5v) bei..
Plot how this absorbed power varies with signal strength W12, and discuss the behavior especially at very small and very large W12. Where does the absorbed power go? -and how does it get there?
A 3.5inch floppy disc has a nominal capacity of 2 MB. Note that there are eight bits to a byte. Estimate the area of magnetic material allocated to each bit of information. Clearly state any assumption made and carefully note any measured quantiti..
Using 4-bit numbers to save space, multiply 3ten x 4ten in binary.
A typical method of measuring the linearity of an amplifier is called the "Two-tone" test. Signals at f1 and f2 are input to the amplifier and the output spectrum is observed. Assuming that signals at 14.1 and 14.2 MHz are input to an amplifier.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd