Design instruction decoder using and-or and inverter gates

Assignment Help Electrical Engineering

Reference no: EM13281744

Design the instruction decoder using AND, OR, and inverter gates todecode the 3-bit op codes (bits D7, D6, D5, of 8-bit instruction)and produce the ADD, SUB, IN, OUT, and MOV control signals (thecontrol signal will be "1" when i asserts) Assuming the followingop codes are used for ADD, SUB, IN, OUT, and MOV instructions:

Instructions Op-code (3-bits: D7, D6, D5)
ADD 001
SUB 011
IN 101
OUT 111
MOV 010

Reference no: EM13281744

Questions Cloud

Design the circuit and perform a spice simulation : The AC amplitude is on the order of 100 to200 mV. Based on LMH6619, design a circuit that will subtracta DC value and amplify the remaining signal by 100, and places theoutput on a 2.5V DC offset. Design the circuit, perform a SPICE simulation and..

What is the profit on the activity : what arbitrage opportunity is available for an investment banking firm? what is the profit on the activity?

Which of the following are prohibited transactions : Bob, a covered participant of the profit sharing plan, borrows $5,000 from his account balance to pay for his first semester in graduate school.

How far should the object be from the center of earth : A force of 5.25 newtons acts on an object of unknown mass at a distance of 6.9..*.10^8 meters from the center of Earth. how far should the object be from the center of Earth

Design instruction decoder using and-or and inverter gates : Design the instruction decoder using AND, OR, and inverter gates todecode the 3-bit op codes (bits D7, D6, D5, of 8-bit instruction)and produce the ADD, SUB, IN, OUT, and MOV control signals (thecontrol signal will be "1" when i asserts)

What does an employee census help to identify : What does an employee census help to identify?

Find the tension in string as the puck revolves around peg : A puck (mass = 0.3 kg) slides without friction on a horizontal plane. It is attached by a light string (length = 1 m) to a ring on a peg. find the tension in the string as the puck revolves around the peg

Find the total complex power supplied by the source : The source feeds two loads, both of whichare Y-connected. The impedance of load 1 is 8 + j6 Ω/φ.The complex power for the a-phase of load 2 is 600 36o VA. Find the total complex power supplied by the source.

What is the speed of the helium atoms in the tank : A 20 liter tank of helium is at a pressure of 190 kPa at a temperature of 0 C. What is the speed of the helium atoms in the tank at this new volume

User Account

All Pages