Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
design an up/down counter that has an input switch x and counts as follows:
if x = 0, the counter counts 1,2,3,4,5,6,7 and repeats
if x = 1, the counter counts 7,6,5,4,3,2,1 and repeats.
The counter should be designed using D Flip FLips and the one hot method. Draw the asm chart and final logic diagram.
A tollgate (vending machine) controller accepts only nickels (5c), dimes (10c), and quarts (25c), and generates control signal to actuate the lever to open the tollgate (or dispense a chosen item in case of vending machine) once 35c or more are re..
The NMOS transistors in the circuit shown in Figure P16.68 have parameters Kn =0.2mA/V2,VTN =0.5V,λ=0,andγ =0.(a)Forgatevoltagesof φ = 2.5 V, determine the quasi-steady-state output voltage for (i) vI = 0
Compare and contrast transmit and receive diversity. Describe how each diversity type lead to an improvement in system performance.
A parallel plate capacitor has gasoline as the dielectric. The area of the plate is 0.25 m^2 and the distance between two plates is 5cm. a. Find the capacitance given that the relative permittivity of gasoline is 2.
The signal given is x(t) =cos(440*2*pi*t) +cos(554*2*pi*t)+cos(659*2*pi*t) Find the complex exponential forier series of the signal and plot k vs Ck for k=-1000 to 1000.
An LED is rated at VF = 1.6 Volts to 2.0 Volts at IF = 20 mA. What value of series resistance is needed to limit the LED current to 20 mA when this LED is connected to a 32 Volts peak source
A point charge of 16 nc is located at Q(2,3,5) in free space and a uniform line charge of 5nC/m is at the intersection of the planes x = 2 and y=4. If the potential at the origin is 100V, find V at (4,1,3).
make a RAM memory using a 2-D array of integers. This RAM will have 8 locations, each 64 bits wide. Both should be changeable and controlled by generics. This memory will be connected to a FIFO controller which I have already coded.
A new type of Schottky diode is optimized for low-voltage applications. It has typical forward voltage drop of 0.2 V, but its leakage current can be as high as 80 mA. It is being considered for a 12 V to 2.5 V converter with 50 W load.
What is the thermal noise level of a channel with bandwidth 10kHz carrying 1000. Watts of power at 50o C?
Let y(t) he the signal at the output of the LTI system when x(t) is the input signal. The following signals are sampled using a train of impulses with periodicity T, signal x(t) is sampled to obtain xc(t), and signal y(t) is sampled to obtain yc(t..
Assume you have a receiver with an overall noise figure of 23 dB and a bandwidth of 1 MHz. Assuming the minimum acceptable SNR at the output of the receiver is 6 dB, estimate the minimum detectable signal level in dBm at the receiver input.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd