Design and simulate a power supply that takes line voltage

Assignment Help Electrical Engineering
Reference no: EM13275013

Design and simulate a power supply that takes line voltage and produces a 15V output with less than .5% ripple voltage.
For your design, provide all the data sheets, calculations and simulations for the output characteristic, ripple voltage, condcution interval, peak current, and diode power loss.

Provide percent errors for all of the characteristics above.

Full-Wave Bridge Rectified

Reference no: EM13275013

Questions Cloud

Determine the frequency components of the detector output : Consider a message signal m(t) containing frequency components at 100, 200, and 400 Hz. This signal is applied to a SSB modulator together with a carrier at 100 kHz, with only the upper sideband retained.
Discuss extrinsic rewards for healthcare professionals : Discuss extrinsic rewards for healthcare professionals, and provide at least three specific examples of extrinsic rewards that relate to healthcare organizations.
The weekly sales are in thousands of dollars : Q. An owner of a chain of stores would like to predict weekly sales based on the number of customers who made a purchase. A random sample of 10 stores were selected. The weekly sales are in thousands of dollars.
What is the straight-debt value of the bond at the time : If the bonds were not convertible, investors would require an annual nominal yield of 10%. What is the straight-debt value of the bond at the time of issue?
Design and simulate a power supply that takes line voltage : Design and simulate a power supply that takes line voltage and produces a 15V output with less than .5% ripple voltage. For your design, provide all the data sheets, calculations and simulations for the output characteristic
Lettering techniques : Draw the top 10" of a 2"-wide stake on a piece of paper and place the following information on it: Station 3+56, Offset 25 feet Left of centerline, Fill 4.5 feet at a 2:1 slope. Use your best lettering techniques.
Explain hbr is mixed with water : HBr is mixed with water. Which is the best description of what you would expect to find in the solution
What is the implied value of each warrant : Upstate Water Company just sold a bond with 80 warrants attached. The bonds have a 20-year maturity and an annual coupon of 12%, and they were issued at their $1,000 par value. Currently, the yield on similar straight bonds is 15%. What is the imp..
What coupon interest rate must the company set : Each warrant is expected to have a market value of $4.00 given that the stock sells for $42. What coupon interest rate must the company set on the bonds in order to sell the bonds-with-warrants at par?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find a possible series rl circuit equivalent to n

With |V| = 100 V, the instantaneous power p(t) into a network N has a maximum value 1707 W and a minimum value of -293 W. Find a possible series RL circuit equivalent to N.

  Find actual carrier concentrations and doping concentration

A gallium-arsenide crystal at 200K containing only donor impurities was found to have hole concentration to be one fifth that of the electron concentration. Determine the actual carrier concentrations and the doping concentration of the crystal.

  What is the velocity of propagation in the cable

A certain transmission line is 10 meters long. Measurements indicate that the total inductance of the cable is 16 uH. Standing wave measurements indicate that the voltage reflection coefficient at the load is 0.5 + j0

  Design a double sideband amplitude modulation modulator

Design a Double Sideband Amplitude Modulation (DSBAM) modulator and demodulator system using the SystemView software. The modulating wave m(t) = Amcos(2pifmt) and the carrier wave c(t) = Accos(2?fct) have the following parameters

  Calculate the maximum allowable gate drive power

A thyristor is triggered by a pulse of train of 5kHz.The duty ratio of the pulse train are 0.5. If allowable average gate power is 100W, calculate the maximum allowable gate drive power.

  Compute the maximum and minimum values of the amplifier

A JFET has the following ratings: gm0 = 4000µs at VGS off ( ) = 6 Volts and gm0 = 2000µs at VGS off ( ) = 2Volts. The component is used in a common source amplifier with values of RD = 3.3 Kohm, RL = 4.7 K ohm,and VGS = 750

  What is the change in the sound intensity level in db

A listener increases his distance from a sound source by a factor of 4.11. Assuming that the source emits sound uniformly in all directions, what is the change in the sound intensity level in dB

  Find the joint probability density function of y1 and y2

X1 and X2 are two independent Gaussian random variables each with mean zero and unit variance.

  How much current is there through the resistor

a 10 ohm resistor is connected across a 12 v battery. How much current is there through the resistor?

  Find two renewable energy application for converters

Find two renewable energy application where ac/dc converters are used. Explain qualitatively the role of the converter in the application

  What would be the baud rate if the intial value of the timer

Write a sequence of instructions to initialize and run the timer to geneate an 800 baud rate clock. what would be the baud rate if the intial value of the timer was set to 9AH

  How much power would that be on the average

A common energy consumption for a family is about 1000 kW hr / month. How much power would that be on the average. (Hint: Notice that hour and month are both units of time so kW hr per month is really a power unit.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd