Design an end connection using longitudinal welds

Assignment Help Mechanical Engineering

Reference no: EM131382377

A roof truss tension member is made up of 2L6×4× 1 2 (total A g =9.50 in . 2) of A36 steel as shown. The bolts are - 3 4 -in- diameter. A325-N high-strength bolts in standard holes.

Compute the tensile capacity P for the connection shown. The special note for angle tension connections of given Problem applies.

Problem
Design an end connection using longitudinal welds and an end transverse weld to develop the full tensile capacity of the angle shown. Use A36 steel and E70 electrodes.

Note: A reduction coefficient for the computation of the net area for a tension member that does not have all its cross-sectional elements connected to the supporting member is commonly used. This factor is neglected in this text

684_Fig 6.jpg

Reference no: EM131382377

Questions Cloud

Create a probability model for the amount you win : Pick a card, any card. You draw a card from a deck. If you get a red card, you win nothing. If you get a spade, you win $5. For any club, you win $10 plus an extra $20 for the ace of clubs.

Calculate the number of bolts required for the connection : The connection is subjected to an axial tensile load of 100 kips.- Calculate the number of bolts required for the connection and sketch the bolt layout pattern.

What you found most interesting or why you chose the article : Main point(s) of the article-and a few specific and powerful details the writer uses to support the main points. If time: What you found most interesting and/or why you chose the article.

Compute the allowable tensile load for the double shear : Compute the allowable tensile load for the double-shear butt joint shown. The plates are equivalent to A992 steel. The bolts are 7 8 -in. - diameter A325-N high-strength bolts in standard holes.

Design an end connection using longitudinal welds : Design an end connection using longitudinal welds and an end transverse weld to develop the full tensile capacity of the angle shown. Use A36 steel and E70 electrodes.

What do you think about the notion presented by terris : What do you think about the notion presented by Terris that Lockheed's ethics program does little to prevent ethical breaches at the highest level of the organization?

Find the man’s expected profit : Assuming that the two races are independent events, find the man's expected profit.

Describe corporate social irresponsibility : Describe corporate social irresponsibility. Where do you stand on the issue of CSR v CSI? Do corporations have a right to ignore their responsibility to some stakeholders in order to add to the short term bottom line?

Determine the allowable tensile load : Determine the allowable tensile load that can be applied to the connection shown. The plates are of ASTM A36 steel and the weld is made using an E70 electrode.

User Account

All Pages