Reference no: EM13718085
We wish to design an automatic speed control for an automobile. Assume that
1) the car has a mass m of 1000 kg,
2) the accelerator is the control U and supplies a force on the automobile of 10 N per degree of accelerator motion, and
3) air drag provides a friction force proportional to velocity of 10 N · sec/m.
a) Obtain the transfer function from the control input U to the velocity fo the automobile
b) Assume the velocity changes are given by
V (s) =1/(s+0.002) U(s) + 0.05/(s+0.02) W(s)
Where V is given in meters per second, U is in degrees, and W is the percent grade of the road. Design a proportional control law U = -Kp V that will maintain a velocity error of less than 1 m/sec in the presence of a constant 2% grade.
c) Discuss what advantage (if any) integral control would have for this problem.
d) Assuming that pure integral control (that is, no proportional term) is advantageous; select the feedback gain so that the roots have critical damping (? = 1).
|
Explain a foundational knowledge of childrens development
: Analyzing child development research and find one additional scholarly source - Explain a foundational knowledge of children''s development?
|
|
What is the pressure of this same gas
: A tank of oxygen holds 14.0L of oxygen (O2) at a pressure of 30.0atm . When the gas is released, it provides 230.L of oxygen. What is the pressure of this same gas at a volume of 230.L and constant temperature?
|
|
Data from this table of thermodynamic properties
: Use the data from this table of thermodynamic properties to calculate the maximum amount of work that can be obtained from the combustion of 1.00 moles of ethane, CH3CH3(g), at 25 °C and standard conditions.
|
|
Write a program that will open a blastn
: Write a program that will open a BLASTN (nucleotide to nucleotide search) output file, parse out specific information, and produce formatted output that will be written to STDOUT
|
|
Design an automatic speed control for an automobile
: We wish to design an automatic speed control for an automobile. Assuming that pure integral control (that is, no proportional term) is advantageous; select the feedback gain so that the roots have critical damping (? = 1).
|
|
Melt along the interface between the fe-si alloy-al coating
: Your company is considering creating an alumina coating by immersing an Fe-Si alloy into an Al melt, withdrawing the coated Fe-Si, and then oxidizing the Al coated alloy at 1000°C in air to form an alumina coating.
|
|
Describe what a riser is in the context of sand casting
: Describe what a riser is in the context of sand casting. What are its main functions? In light of Chvorinovs rule, what should be taken into account when determining the geometry, dimension, and location of a riser in a sand casting mold?
|
|
Volume rate of flow and time required to fill mold cavity
: A mold has a downsprue of length = 6.0 in. The cross-sectional area at the bottom of the sprue is 0.45 in2. The sprue leads into a horizontal runner which feeds the mold cavity, whose volume = 75 in3. Determine (a) the velocity of the molten metal fl..
|
|
Determine how long it will take for the casting to solidify
: In the casting of steel under certain mold conditions, the mold constant in Chvorinov's Rule is known to be 4.0 min/cm2, based on previous experience. The casting is a flat plate whose length = 35 cm, width = 10 cm, and thickness = 15 mm. Determine h..
|