Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design an air-filled C-band (5-8 GHz) rectangular waveguide such that the center frequency of this band (f= 6 GHz) is at least 25% higher than the cutoff frequency of the TE10 mode and at least 25% lower than the cutoff frequency of the next highest mode, so that the only TE10 mode of propagation is.
Assuming exact valued resistors what output voltage (measure to ground) and equivalent output resistance result if the resistor used are not ideal but have a +-5% manufacturing tolerance what are the extreme output voltafes and resistances that ca..
A 32 channel TDM system samples messages at 8000 samples per second, uses 2 bits for frame synchronization and 8 bits per sample. What must be the highest frequency in the message spectrum to guarantee perfect recovery of the original signal
A certain power amplifier with crossover distortion has the input/output voltage relationship vo (t) = vi (t)3 (2.39) a) Use example voltage values to show that this does not satisfy the relationship. b) Let vi (t) = sin (pi t) .
Write an assembly language program to turn the stepper motor. Start a new project. Set bits 1 to 4 of PORT P ($25A) to 1 (output direction) Do not set bits 0, and 5-7, setting these bits may produce unexpected results.
Determine the settings Z1, Z2 & Z3 for the relay at B12.
And how long it will take to reach that temperature assuming no heat lost in the process and comments on your results and may research the properties of nichrom wire to determine the resistivity of the wire
A p-type wafer has a diffused Phosphorous n-type junction with a junction depth of 0.15µm. a) If the wafer (no pre-existing oxide) is to be oxidized at 1000-oC for two hours to form a ‘dense, non-porous, high-quality' gate oxide.
Determine the number of gates needed to implement an eight-bit carry-lookahead adder assuming that the maximum fan-in for the gates is four.
The parameters of a certain transmission line operating at ω = 6×108 rad/s are L = 0.35μH/m, C = 40 pF/m, G = 75 μS/m, and R = 17 Ω/m => α=0.0943 Np/m, β=2.2467 rad/m, λ=2.7966 m, Z0 =93.623-j3.6368
Why do we want to measure the voltage at a different point than the current in the four point probe method
What closed-loop gain would you expect. If a dc voltage of +1.00 V is applied at the input, what output result. If the 10-k ohm resistors are said to be "1% resistors," having values somewhere in the range (1 ± 0.01) times the nominal value
A 75-W, 120-V tungsten incandescent lamp has a resistance of 19.2Ω when no current flows through it. 1.What is the resistance of the lamp when it is connencted to 120-V cource
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd