Design a minimum two-level nor-gate network

Assignment Help Electrical Engineering
Reference no: EM13252129

Given the function F(a,b,c,d)=a'b+ad'+ab'

a) Design a minimum two-level NOR-gate network to realize the above function.

b) Design a minimum three-level NOR-gate network to realize the above function.

Reference no: EM13252129

Questions Cloud

What would va need to be if wanted the motor to operate : With a 500hp shunt wound DC motor, at 1800rpm, 500Vdc, FLA is 800Adc, Ra is 0.025 and Rf is 400. What would Va need to be if you wanted the motor to operate at 1000rpm at rated torque. Keeping the field current constant.
What is the focal length of the diverging lens : A converging lens has 31.3 cm focal length, and is placed 20.9 cm behind a diverging lens. Parallel light strikes the diverging lens, What is the focal length of the diverging lens in cm
Explain anode and cathode half-reaction : The reactions represented below are all spoontaneous as written. For each, write the anode and cathode half - reactions and indicate the signs of the electrodes.
How far away from the subject was the reporter standing : A movie star catches a reporter shooting pictures of her at home. She claims the reporter was trespassing and to prove her point, How far away from the subject was the reporter standing
Design a minimum two-level nor-gate network : a) Design a minimum two-level NOR-gate network to realize the above function. b) Design a minimum three-level NOR-gate network to realize the above function.
Employees to help them in their retirement : You as CEO of Land-Tech have agreed to set some money aside for your employees to help them in their retirement.  The plan will be cost-shared between you and your employees.
What is the perceived colour if three colors are mixed : what is the perceived colour if you mix red ,green and blue dyes in equal proportion and why  What about red and green frequiencies only
What is the magnetic moment of the rotating ring : A uniform ring with a radius of 2.15 cm and a total charge of 6.37 ?C rotates with a constant angular speed of 3.84 rad/s, What is the magnetic moment of the rotating ring
Write a memo to board describing what actions must be taken : Write a memo to the Board describing what actions must be taken before the performance management program can be effectively implemented. Discuss the primary goal of each of these interventions and explain how you will know that these goals have b..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is function of enable control input of tri-state buffer

What is the function of the enable control input of a tri-state buffer If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines What does happen when this restriction is viola..

  Indicate the peak current in each of the resistors

R1=1k ohms, R2=1.5k ohms and R3=3k ohms. Assume an ideal opAmp. Indicate the PEAK current in each of the resistors.

  Find total impedance of network if frequency is given

In a circuit, there is a resister, a conductor and a capacitor connected to voltage source. R = 25 ohms, L = 20 milliH, and C = 50 microF. a) Find the total impedance of the network if the frequency is 60 Hz.

  How could the rising-tone acoustical illusion

How could the rising-tone acoustical illusion be modified to obtain a tone that goes up and down in pitch at the same time.

  Determine the location of the poles and zeroes

Using MATLAB, plot the pole zero map and the Bode plot of the two transfer functions and paste the graphs below. Identify and briefly discuss the differences between the Bode plot of the two transfer functions.

  Explain what is the resolution of each quantizer

Supply the quantisation levels (including zero) that are available. Do this for both the three and 4-bit ADC in table form. What is the resolution of each quantizer?

  Calculate current in incoming and outgoing transmission line

three single-phase transformers rated at 250kVa, 7200V/600, 50Hz, are connected in wye-delta on a 12470V, 3 phase line, if the load is 450kVA, calculate the current in the incoming and outgoing transmission lines and in the primary and secondary w..

  What is minicircuits rf mixers would be suitable for design

You are designing a 2.4 GHz receiver with a 140 MHz IF. System design constraints require that the local oscillator power be minimized to reduce the potential for interference to other systems as well as to reduce the receiver power consumption.

  Make a program that will read a file from a disk

C++ Program Help, make a program that will read a file from a disk and will take the first letter of each word and and make that into a sentence.

  Find total energy stored in the battery of connected bulb

Then find the total energy stored in the battery before it is connected to the bulb. Determine the total amount of charge that has pessed through the wires that connect the battery and the bulb.

  Sketch sop realization using nands and pos using nors

Design a circuit that has 4 inputs, WXYZ, and two outputs, f and g, where W is the most and Z is the least significant bit. The output f is asserted whenever the two-bit number WX is greater than the two-bit number YZ.

  Design a through-beam photoelectric sensor

When the beam is not broken, light from the transmitter hits the receiver and turns on the output transistor from the receiver. Their purpose is to detect objects as the objects break the beam. design a through-beam photoelectric sensor

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd