Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The objective of this lab is to design a digital clock using a DS1307 external clock chip. The first step is to interface the clock chip to the microcontroller using an I2 C network. The second step is to design low-level drivers to allow the microcontroller to send and receive data from the DS1307. The next software layer includes functions such as Set Time, Format Time, and Read Time. The highest level is a main program that implements a digital clock using an LED or LCD display. Two, three, or four momentary switches will be used to control the operation of the digital clock.
The concentration of a metabolite within the bloodstream is 100 parts per million. Assume that 1000 mg of metabolite is to be used as a tracer, it is injected over 5 min and the downstream concentration is measured to be 4000ppm.
An idealized reservoir contains an ideal gas at a pressure of 4410 psia and a temperature of 91degrees C. Under these conditions the volume of this gas in the reservoir is 10^9 ft^3. What would be the volume of this gas at standard temperature and co..
A piston-cylinder device with a set of stops initially contains 0.6kg of steam at 0.8MPa and 500°C. The location of the stops corresponds to 60percent of the initial volume. Now the steam is cooled. Determine the compression work of the final state ..
Derive formulas for the maximum tensile stress σt and the maximum compressive stress σc in the beam for θ= 0, 45°, and 90°.
A piston-cylinder assembly which initially has a volume of 1 m^3 is filled with 0.7 kg of air. The pressure on the air is always maintained at 1.2 bars. Heat transfer is allowed to take place until the volume is 60 percent of the initial value. You m..
the properties of composites are governed by the properties of the constituent materials the volume contents of the
consider a steam power plant that operates between the pressure limits of 10 mpa and 20 kpa. steam enters the pump as
Assuming that the middle cantilever supports 50% of the load and each outer cantilever supports 25% of the load, determine the required dimensions b and h.
a six liter 6 l pot is fitted with a heavy lid that allows a maximum of 200 kpa of absolute pressure. heat is added to
Tests on a small scale tank 0.3 m in diameter show that a blending process between two miscible liquids (both aqueous with properties the same as water) is complete after 1 minute when using an impeller speed of 250 revolutions per minute. It is d..
the metal rhodium has a fcc crystal structure. if the angle of diffraction for the 311 set of planes occurs at 36.12deg
A flat disk of outer radius b-125mm and inner radius a=25mm is shrink-fitted onto a shaft of radius 25.05mm. Both members are made of steel with E=200Gpa, v=0.3, and p=7.8 KN.s2/m4. Determine (a) the speed in rpm at which the interface pressure becom..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd