Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A stream with a flow rate of 65,000 lb/h having thefollowing composition is to be condensed.
The stream will enter the condenser as a saturated vapor at 18 psia, and a maximum pressure drop of 2 psia is specified. The temperature of the condensate leaving the unit should not exceed 180°F. Cooling will be supplied by water from a cooling tower entering at 90°F and 40 psia, with a maximum allowable pressure drop of 10 psia. Use any available software to design a condenser for this service.
superheated water vapor enters and insulated turbine operating at steady state at 20 bar and 400 degc and exits at 1.5
Calculate the unit cell edge length for an 80 wt% Ag-20 wt% Pd alloy. All of the palladium is in solid solution, the crystal structure for this alloy is FCC, and the room temperature density of Pd is 12.02 g/cm3.
Considering only the load P, calculate the maximum tensile stress σt, maximum compressive stress σc, and maximum shear stress τmax at point A, which is located on the top of the bracket at the support.
Arc Length Element Find the square of the element of arc length ds in cylindrical and spherical coordinate systems. Plane through Three Points Show that the equation of a plane that includes the three points
a regenerative steam power cycle has a closed feedwater heater that heats 20 kgs of water from 100degc 20 mpa to
Damping experiments on iron were made using a torsion pendulum with a natural frequency of 0.65 cycles/s. The experiments were run at var- ious temperatures and the maximum log decrement was found at 35?C.
A paper clip is made of wire 0.7 mm in diameter. If the original material from which the wire is made is a rod 25 mm in diameter, calculate the longitudinal engineering strain and true strain that the wire has undergone during processing.
The tensile strength of iron-carbon alloys increases as the percent carbon increases up to about 1.5 to 2%. Above this the tensile strength drops rapidly with increased percent carbon. Speculate about the nature of this abrupt change.
steam enters a turbine at 12.5 mpa and 500o c. the out let flow is measured as 20 kpa with a vapor quality of 90. if
saturated liquid water is compressed from 100 kpa state 1 to 2.5 mpa state 2 in an adiabatic pump having 85 isentropic
Steam flows through a small steam turbine at the rate of 10,000 kg/hr, entering at 600 C and 2 MPa and emerging at 0.01 MPa with 4% moisture. The flow enters at 50 m/s at a point 2 m above the discharge and leaves at 80 m/s. Compute the shaft-power o..
Then compute the average of ten values to determine the average velocity. Finally, compute the volume flow rate from Q = Av.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd