Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A multivariate linear regression model has been built to predict the heating load in a residential building based on a set of descriptive features describing the characteristics of the building. Heating load is the amount of heat energy required to keep a building at a specified temperature, usually 65° Fahrenheit, during the winter regardless of outside temperature. The descriptive features used are the overall surface area of the building, the height of the building, the area of the building's roof, and the percentage of wall area in the building that is glazed. This kind of model would be useful to architects or engineers when designing a new building. 25 The trained model is
Four point charges of 1 C are located at the corners of a square with a side a =1 m. Find the magnitude of the force experienced by each charge.
a) Draw the state diagram for a FSM that detects the sequence r = 0101 (without overlaps). b) The FSM in part a can beimplemented with 3 FFs. Assume the state assignments are A = 000, B= 001, C = 100, D = 110
A charge q is placed between two grounded infinite parallel conducting planes which are a distance "d" apart (see figure attached). Let ε_r = 1.
What is the minimum sampling frequency to be able to avoid aliasing if your system has 10Hz, 100Hz and 1500Hz mixed in a signal
The 300-kg block is acted upon by a force P, pulling it as shown. P makes an angle of 36o with the horizontal. If the coefficient of sliding friction between the block and the floor is 0.35, determine the force required to start moving the block.
Output impedance with a resistor R across the constant current source - This is a linear model of the transistor. So we are assuming we have biased it at a suitable DC operating point which provides.
Given that the capacitance of the plates is 4 nF, sketch the current flowing through the plates.
What are two of the major considerations that factor in the design of a substation. Give a couple of examples of station layouts where these factors are clearly demonstrated. What typical grounding materials are used in substations.
Write the VHDL architecture file for the Y(5) output only for a 8-to-1 demultiplexer. The inputs are D, the selects S0-S2, and the ouputs Y(0)-Y(7). the select lines are bit_vector types, the data is bit type and the outputs are bit_vector types.
The length of a wire of a potentiometer is 100 cm, and the e.m.f. of its stand and cell is E volt. It is employed to measure the e.m.f. of a battery whose internal resistance is 0.5 ohm. If the balance point is obtained at l =3..
Design a non-inverting amplifier with a voltage gain of approximately 12 with an input resistance of 12kOhm. Use SPICE to confirm the result using a simple model of the OpAmp
design a sequential circuit to control the operation of a vending machine which dispenses a $0.25 product. I need a state diagram and a state table. please help! More info: The circuit has three inputs, N, D, Q, and two outputs, P and C.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd