Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
a) Design a two-stage signal processoras a distortion box for and electric guitar. The first stage applies a variable gain magnitude in the range 13.3 to 23.3 while the second has a gain of 1/13.3. The distortion effect relies on intentionally driving the first stage amplifier into saturation when its gain is above 13.3. Use a 10 kOHM potentiometer and resistor with value between 1kohm and 100kohm
b) derive a general formula for percent clipping of a unit amplitude sinusoidal test signal; this is the percent of time during one period in which the signal is clipped. The formula includes peak sinusoidal voltage Vp that would appear at the ouput of the first stage amplifier with saturation ignored and actual maximul due to saturation Vs.
A circuit consists of two 1.0 k ohm resistors in series and this series being connected in parallel to a 570 ohm resistor. If the voltage drop across one of the 1.0 k ohm resistors is 4.5 V, what is the voltage drop across the 570 ohm resistor
Design an XOR gate using standard CMOS logic and with pass-transisitor logic and determine the number of transistors (NMOS and PMOS) required for each implementation.
The base class must also have a virtual print() function that displays the class name. Randomly assign print functions in three other classes that display the class name. Create 7 pointers of the base class and have them point to all the classes.
An uncharged capacitor and resistor are connected in series with a 12V source and switch. What is the voltage across the capacitor after the switch is closed and the capacitor is fully charged
Design and test a 4-bit ripple carry adder, i. e., an array of 4 full adders, that adds any 4-bit binary number A3A2A1A0 to the 8-4-2-1 BCD code of the third and fourth non-zero and different digits of your Red ID number.
The space between the plates of a parallel-plate capacitor is filled with a dielectric whose permittivity varies linearly from f1 at one plate (located at y=0) to f2 at the other plate (located at y=d).
sketch the spectrum
A transistor current source (also known as current ''sink'') was built with a 2N3904. The Ic was measured for different values of a load resistance. It was noticed that Ic was pretty much constant for the first 1900 ohms values
Absorption loss of metal shielding, A plane metal shield offers an absorption loss of 30 dB at a frequency of 10 kHz to normally incident radiated emission.
Contains basic function in MATLAB files. Write MATLAB script(s) to plot the basic signals below in two subplots. The upper subplot should be a continuous waveform (don't do g) and the lower subplot should be a discrete plot.
A binary channel with capacity 36 k bits/sec is available for PCM voic transmission. If signal is band limited to 3.2 kHz, then what will be the appropriate values of quantizing level L and the sampling frequency.
which has higher resistance: the copper wire that carries the power from Bonneville Dam to your circuit breaker box, the copper wire that carries the power from there to your computer, or the copper wire that runs from the from one side of the chi..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd