Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Important information about Frequency DividerDesign a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input. Use the 74163 IC in Multisim. Simulate, construct, and test the frequency divider circuit. Use a frequency counter in Multisim to verify the proper output frequencies of your circuit design.
What is the maximum bandwidth of the low pass filters at the receiving end of the link? What bandwidth would you recommend for the LPFs?
Determine the Laplace transform of the above signals (use properties of the Laplace transform) including the corresponding region of convergence.
Determine the voltage required on the input of the amplifier to give the maximum output of 85 dBuV. If the signal level from the aerial is 5 dBmV and the input noise level is 20 dBuV, calculate the signal-to-noise ratio on the output of the amplifi..
The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.
Surface integral for jet engine. The air-gas exhaust velocity from a jet engine varies linearly from a maximum of 300 m/s at the center of the circular exhaust opening to zero at the edges. If the exhaust diameter is 1.6 m, find thq exhaust flow.
Laplace transform of a pulse, Consider computing the Laplace transform of a pulse: use the integral formula to find P(s)
Digitizing an Audio Signal, PAM, ADC, An audio signal has a bandwidth that extends from 100 Hz to 10 kHz. The signal is sampled to create a PAM signal and then digitized by an analog to digital converter (ADC) that has 8 bits.
Calculate the critical clearing angle and plot the swing curve for the machine - What is the power angle at the end of the 10 cycles?
Eigenfunctions and LTI systems, The eigenfunction property is only valid for LTI systems. Consider the cases of nonlinear and of time varying systems.
Characteristics of a filter, A filter has the following characteristics: Attenuation = 3.0 dB from 0 Hz to 2 kHz. From 2 kHz to 20 kHz attenuation increases from 3 dB to 23 dB in a straight line when plotted on axes of power in decibels (vertical a..
What are the essential features of an ideal op amp? Identify the terminals of an op amp. Draw its equivalent circuit. Define virtual ground and what is difference amplifier? Draw its circuit. Define C.M.R.R.
Explain the following terms; (i) critical radius of insulation. (ii) economic lagging thickness.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd