Decide the amount of heat transfer from the air

Assignment Help Mechanical Engineering

Reference no: EM13703069

500kg of air at 35 degrees Celsius dry-bulb and 20 degrees Celsius wet-bulb temperatures is cooled to 13 degrees Celsius dry-bulb and 90% relative humidity. Decide the amount of heat transfer from the air in MJ

Reference no: EM13703069

Questions Cloud

A motor has a disk mounted on its shaft : A motor has a disk mounted on its shaft. The disk has a diameter of 1 foot and weighs 60 pounds. Starting from rest, the motor rotates at 350 rpm after 5 seconds. If the motor has a 92% efficiency, determine the input power in watts.

Exhaust steam from a turbine exhausts onto surface condenser : Exhaust steam from a turbine exhausts onto a surface condenser at a mass flow rate of 8000lbm/hr, 2psia, and 92% quality and leaves the condenser as a saturated liquid. Cooling water enters the condenser at 74 degrees far. and leaves at the steam inl..

Calculate valve overlap in crank angle for operational speed : A small five-cylinder CI automobile engine operates with a variable valve timing control system without a camshaft. At operational speed of 3500rpm the intake valve opens 32deg bTDC and closes 57deg aBDC. The exhaust valve opens 52deg bBDC and closes..

Nonqualified deferred compensation : What is meant by the term nonqualified deferred compensation for income tax purposes, and for whom is it most often used - Discuss the applicability of IRC Section 409(a) to each plan.

Decide the amount of heat transfer from the air : 500kg of air at 35 degrees Celsius dry-bulb and 20 degrees Celsius wet-bulb temperatures is cooled to 13 degrees Celsius dry-bulb and 90% relative humidity. Decide the amount of heat transfer from the air in MJ

What is the largest diameter the steel shaft : A brittle cast iron (E = 15 Msi, ? = 0.2, Sut = 30 ksi, Suc = 100 ksi) hub is shrink-fit onto a solid carbon steel shaft. The hub has initial inner and outer diameters of 3.000 and 6.000 inches respectively. What is the largest diameter the steel sha..

Completely drill out the crack with hole : A long rectangular bar 20 mm wide and 10 mm thick made of hot-rolled 4340 carbon steel (Sy = 860 MPa, K1c = 99 MPaÖm), is found to have a centrically located through-thickness crack 8mm wide. Is it best to a) leave the crack alone, b) drill a 5 mm di..

Dispute resolution methods : Choose 2 dispute resolution methods for each of your scenarios fromthe following list. Some of these are described in the Astor and Chinkin reading

Determine the input power in watts : A motor has a disk mounted on its shaft. The disk has a diameter of 1 foot and weighs 60 pounds. Starting from rest, the motor rotates at 350 rpm after 5 seconds. If the motor has a 92% efficiency, determine the input power in watts.

User Account

All Pages