Current is needed in the windings of a long solenoid

Assignment Help Physics
Reference no: EM13664230

What current is needed in the windings of a long solenoid that has 850 turns uniformly distributed over a length of 0.410 m to produce at the center of the solenoida magnetic field of magnitude 1.00 x 10-4 T?

Reference no: EM13664230

Questions Cloud

Evaluate what is the speed of the ball after collision : A bat and ball approach one another each with the same speed of 1.50 m/s collides. Evaluate what is the speed of the ball after collision
What is the refractive power of a magnifying glass : A stamp collector is viewing a stamp by a magnifying glass held next to her eye. Her near point is 25 cm from her eye.(a) What is the refractive power of a magnifying glass that has an angular magnification of 5.2 when the image of the stamp is locat..
Electron is trapped in a one-dimensional infinite potential : An electron is trapped in a one-dimensional infinite potential well that is 310 pm wide; the electron is in its ground state. What is the probability that you can detect the electron in an interval of width δx = 5.0 pm centered at x = 34 pm?
Determine the resistance of the path through the person : A heart defibrillator passes 12 Amp of current through a patient's torso in 3 x 10-3 sec to restore normal beating of the heart. Determine the resistance of the path through the person
Current is needed in the windings of a long solenoid : What current is needed in the windings of a long solenoid that has 850 turns uniformly distributed over a length of 0.410 m to produce at the center of the solenoida magnetic field of magnitude 1.00 x 10-4 T?
Find the magnitude of the average force of the ground : A 0.5 kilogram rubber ball is dropped from a height of 3.0 meter above a hard concrete ground. Find the magnitude of the average force of the ground on the ball during the interaction
Suppose light with a wavelength : Discover the minimum aperture diameter of a camera that can resolve detail on the ground the size of a person(2.0 m) from an SR-71 Blackbird airplane flying at an altitude of 29 km.
Diameter carries water into the basement of a house : A water pipe having a 2.9 cm inside diameter carries water into the basement of a house at a speed of 0.92 m/s and a pressure of 170 kPa. The pipe tapers to 1.0 cm and rises to the second floor 7.1 m above the input point. The speed at the second flo..
Find the magnitude of the change in momentum of the baseball : A pitcher pitches a baseball of mass 0.20 kilogram. Find the magnitude of the change in momentum of the baseball

Reviews

Write a Review

Physics Questions & Answers

  Assuming the motion takes places in the plane of the plate

A thin homogeneous plate has the shape of an equilateral triangle and is suspended from one apex, acting as a physical pendulum. Use the Lagrangian to obtain the equation of motion and find the frequency of small oscillations, assuming the motion tak..

  Find the magnitude of the force exerted by the hail on roof

The hail comes straight down at a mass rate of m/?t=0.069 kg/s and an initial velocity of v0= -15 m/s. calculate the magnitude of the force exerted by the hail on the roof

  What is the final velocity of the plane

A missile of mass 1.20 102 kg is fired from a plane of mass 4.85 103 kg initially moving at a speed of 3.35 102 m/s. what is the final velocity of the plane?

  Find the radius of the circular path the electron follows

A cosmic ray electron moves at 7.85 x 10e6 m/s perpendicular to the earth's magnetic field at an altitude, What is the radius of the circular path the electron follows

  What is the balls speed as it leaves the roof

At the instant a ball rolls off a rooftop it has a horizontal velocity component +12.0m/s of and a vertical component (downward) of 10.0m/s, What is the ball's speed as it leaves the roof

  What is the power supplied by the person pulling the bar

A magnetic field of 3 Tesla is oriented into the page. A 10 cm long conducting bar is pulled to the right at a constant speed of 3.4 m/s. What is the power supplied by the person pulling the bar

  Estimate what force is required to hold the ball

A rubber ball filled with air has a diameter of 25.0 cm and a massof 0.540 kg. What force is required to hold the ball

  Which is the following statements is true

Select all that apply. Which is the following statements is true?

  What is the next highest frequency

A microphone is located on the line connecting two speakers that are 0.514 m apart and oscillating 180° out of phase. What is the next highest frequency that produces an interference maximum at the microphone's location

  What is the amplitude of oscillations

A 0.1 kg block is attached to a spring with a constant 2.5 N/m and oscillates on a frictionless table. Its velocity is 0.2m/s when x=0.05. What is the amplitude of oscillations? What is the ball's maximum acceleration?

  What is the exact current through the given resistor

A 224-? and a 211-? resistor are connected in series across an unspecified power supply. what is the exact current (in A) through the 211-? resistor

  How fast will the electron be moving

An electron starts from rest 36.5cm from a fixed point charge with Q = -0.105?C. How fast will the electron be moving when it is very far away

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd