Constructive interference of sound waves occurs

Assignment Help Physics
Reference no: EM13558793

Constructive interference of sound waves occurs when:

The soundwaves are 0 degrees out of phase
The sound wavesare 90 degrees out of phase
The sound wavesare 180 degrees out of phase
The sound wavesare 360 degrees out of phase

Reference no: EM13558793

Questions Cloud

Should the traveling distance of initial acceleration : Should the traveling distance of initial acceleration (before thespeed reaches 0.10c ) be considered while solving the required time(t)?
Explain what is the formula of the original sample : When 3.761 g of a hydrate of strontium chloride is heated to 60 degree celsius it forms strontium chloride dihydrate of mass 2.746 g. What is the formula of the original sample
Find the resulting amplitude of motion of there maining mass : A mass m is connected to the bottom of a vertical spring whose force constant is k. Attached to the bottomof the mass is a string that is connected to a second mass m, as shown in the figure.
Magnesium sulfate heptahydrate is needed to react with hpo42 : What volume of 0.450M MgSO4 x 7H2O (magnesium sulfate heptahydrate) is needed to react with HPO4^2- in 8.25 grams of fertilizer
Constructive interference of sound waves occurs : Constructive interference of sound waves occurs when:
Find at what distance wouldit begin to cause pain : At a distance of 10 Km, a 100 Hz horn, assumed to be anisotropic point source, is barely audible. At what distance wouldit begin to cause pain
Define how lower the concentration of iron : The goal of the treatment facility is to lower the concentration of iron to 0.3 mg/L by precipitation. What hydroxide concentration is necessary to obtain this result? What would the pH be for that concentration
Evaluate the magnitude of the torque acting on the loop : A circular wire loop of radius 15.0 cm carries a current of 2.60 A. What is the magnitude of the torque acting on the loop
What acceleration would aproton experience if guns electric : Beams of high-speed protons can be produced in "guns" usingelectric fields to accelerate theprotons. What acceleration would aproton experience if the gun's electric field were 2.23 x104 N/C?

Reviews

Write a Review

Physics Questions & Answers

  How far will the boy have slid

A boy gets ready to slide down an icy hill with his sled.Assume that the friction from the ground is negligible. How far will the boy have slid after 3 seconds with that acceleration

  What is the verticle deflection d of the electrons

A horizontal beam of electrons initially moving at 4.0x10^7 m/s is deflected vertically by the vertical electric feild between oppositely charged parallel plates. the magnitude of the field is 2x10^4N/C. What is the verticle deflection d of the el..

  Find the cutoff wavelength for this metal

When a metal is irradiated with 410-nm photons, the stopping potential is 1.2 eV. Find the cutoff wavelength (in nm) for this metal

  Calculate the distance in feet traveled in this time

a car weighs 2415 pounds and the rocket mounted on the car provides 1500 lbs of constant thrust. calculate the distance in feet traveled in this time

  Find the total mass of vapor in the radiator

One radiator has a volume of 0.09mt³. It contains saturated vapor at a temperature of 100°C. find The total mass of vapor in the radiator

  Calculate the magnitude of charge stored on each plate

Two parallel plates, each of area 6.52 cm2, are separated by 3.00 mm. The space between the plates is filled with air. Calculate the magnitude of charge stored on each plate

  How long does the block remain in contact

how long does the block remain in contact.

  Find required minimum force magnitude

A 53.6 kg crate is dragged across a floor by pulling on a rope attached to the crate and inclined 16.0° above the horizont, If the coefficient of static friction is 0.510, what minimum force magnitude is required from the rope to start the crate mo..

  What is the resistance of resistor

With the switch open the ammeter reads 1.00 A.  What is the resistance of resistor R2 to an appropriate precision and what is the potential difference across R2 when the switch is open?

  What is the applied force

A cable is 5.00 m long and has a diameter of 1.50 mm. The tensile modulus of the cable is 2.50 × 1010 N/m2. A force is applied to the end of the cable and the cable stretches by 3.00 mm. What is the applied force?

  What focal length lens will be required

An instructor wants to use a lens to project the real image of a light bulb onto a screen 1.23 m from the bulb. In order to get the image to be two times as large as bulb, what focal length lens will be required.

  Q1 a small wooden block with mass 0900 is suspended from a

q1. a small wooden block with mass 0.900 is suspended from a lower end of a light cord that is 1.50 long. the block is

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd