Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The decimal digits 0 through 5 are encoded as 3-bit binary numbers. They are transmitted in disjoint windows of length 3 least significant bit first and are input to a Mealy model circuit. The circuit generates an output of 1 (0) when the third bit is received if the 3 bits have even (odd) parity; the circuit output is a don't-care for the first 2 bits. Construct an incompletely specified table for the circuit.
a.) What isthe minimum sampling frequency to avoid aliasing b.)If the sampling frequency of fs=2500 samples/sec is used how many samples must be taken to give a frequency resolution of 10Hz
our senior design team is designing a force sensor to measure a force signal and analyze the signal with a microcomputer (binary system). The analog force signal is between 10 N and 70 N and has the frequency bandwidth of DC - 1000 Hz.
Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C
Transmit this data wirelessly to a base station for storage. How much bandwidth would you need.
When the scope probe is properly calibrated, it can be modeled as a 9[M Ohm] resistor in parallel with a capacitor having a capacitance l/9th that of the oscilloscope input capacitance.
The transformer input is a three wire three phase 120V (line-to-line) system. the transformer output supplies a "Y" connected three phase load with a phase impedance of 600 + j300 ohms. A. sketch the diagram of the system described above.
(1) Explain what happens in a series circuit when the frequency makes Xc equal to XL. Does it have a name (2) What is the relationship between Ic and IL at Is minimum (3) Why is the source current, Is, minimum at certain frequency
A 500V shunt dc motor has a nominal armature current of 40A, and operates at 1200 rpm. if the armature resistance is 0.25 (ohm), calculate The valve of a starting resistor limiting the initial armature current to 60A
Basics problems of Induction motor, The frequency of the induced rotor currents in the rotor of a 60 Hz induction, machine is 2 Hz. Furthermore, the fields in the air gap turn at -40 rpm with respect to the rotor.
The instantaneous power p into a one port containing resistors and inductors has maximum value 100(1+sqrt2) W and minimum value 100(1-sqrt2)W. (note that instantaneous power is measured in W, and it contains various contributions
A proportional control system is to be used to control the wing flap of a jet airplane. The wind load is expected to cause as much as 600 in-lb of torque. The system should be able to keep the flaps with 5o of the set point.
t uses four diodes, each of which can be modeled to have a 0.7-V drop for any current. What is the peak value of the rectified voltage across the load. For what fraction of a cycle does each diode conduct.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd