User Account

All Pages

Consider a bridge type rectifier

Assignment Help Electrical Engineering
Reference no: EM13993623

1 A full-wave rectifier is to be designed to produce a peak output voltage of 12 V, deliver 120 mA to the load, and produce an output with a ripple of not more than 5 percent. An input line voltage of 120 V (rms), 60 Hz is available. Consider a bridge type rectifier. Specify the transformer ratio and the size of the required filter capacitor. Show all work.

2075_11.png

Reference no: EM13993623

Questions Cloud

What type of transistor has an insulated gate : What type of transistor has an insulated gate? 2. An n-channel JFET is biased such that VGS = -2 V using self-bias. The gate resistor is connected to ground.
Calculate the current in the resistor : For the circuit shown in the figure, calculate the current in the 2.00-Ω resistor and the potential difference between points a and b.
Is dv for a cylinder pi r squared times the lengrh : Is dv for a cylinder pi r squared times the lengrh?
What proportion drinks no more than : If the top 5% of coffee drinkers are considered heavy coffee drinkers, what is the minimum number of cups consumed by a heavy coffee drinker? Hint: Find the 95th percentile.
Consider a bridge type rectifier : 1 A full-wave rectifier is to be designed to produce a peak output voltage of 12 V, deliver 120 mA to the load, and produce an output with a ripple of not more than 5 percent. An input line voltage of 120 V (rms), 60 Hz is available. Consider a bridg..
What is the current through first resistor : In the circuit shown in the figure below, ε = 66.0 V, R1 = 46.0 Ω, R2 = 31.0 Ω, and L = 0.300 H. After the switch has been closed a long time, it is opened again. Just after it is opened, what is the current through R1?
Create job description and specifications for your dream job : Create a job description and specifications for your dream job. Design a compensation and benefits package related to your dream job
Explain the significance of hiring the right person : Discuss 2-3 laws that govern human resources (federal or state) in a typical health care organization. Explain the significance of hiring the right person for the right job and how health care organizations can do so in an ethical manner
Find the current in resistor r and find the resistance r : Find the current in resistor R. Find the resistance R. Find the unknown emf ε. If the circuit is broken at point x, what is the current in resistor R?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the minimum number of pins required for a socalled

What is the minimum number of pins required for a socalled dual-op-amp IC package, one containing two op amps What is the number of pins required for a so-called quad-opamppackage, one containing four op amps

  Determine the power factor-complex power and real power

The voltage across a certain load is V = 1200√2

  Determine the steady state probability matrix and note

A solar heating system can recharge (store heat) in a single sunny day enough to provide for the next two days. In otherwords, the only times that the solar heat must be augmented by someother heat source is when there are three of more consecutiv..

  What then is the indicated temperature

Suppose the RTD of (108.1 Ohms) has a dissipation constant of 25mW/°C and is used in a circuit that puts 8 mA through the sensor. If the RTD (108.1 Ohms) is placed in a bath at 100°C, what resistance will the RTD have

  Find the value of the total circuit complex impedance

An input signal of 10V at 0o and a frequency of 1592 Hz is applied to a series RLC circuit with resistor R = 100 ohm, inductor L = 20 mH, and capacitor C = 0.5 F. The value of the total circuit complex impedance is.

  Find resonant frequency fo of ckt for reverse bias voltage

The doping concentrations in a silicon pn junction are Nd = 5 × 1015 cm^3 and Na = 1017 cm^3. The zero-bias junction capacitance is Cjo = 0.60 pF. An inductance of 1.50 mH is connected in parallel with the pn junction.

  Find armature resistance of excited dc motor

A separately excited DC motor runs at1500 rpm under no load with 200 V applied to the armature.The field voltage is maintain at its rated value. The speed of the motor, when it delivers a torque of 5 Nm ,is 1400 rpm.

  What is the reliability and the equivalent mtbf value

What is the reliability, the equivalent MTBF value, and the equivalent failure rate for a system that has a primary microprocessor circuit board and a secondary microprocessor circuit board that is hooked up in standby redundancy

  What impact would time and temperature have on a circuit

Explain why it is unlikely one would encounter a circuit exhibiting a critically damped response in practice. What impact would time and temperature have on a supposedly "critically damped" circuit

  Sketch the resulting output and including numeric values

A R-C high-pass filter contains a 1 µF capacitor and a 1k resistor. Suppose a single "square" voltage pulse of 5 V for 1 ms duration is applied to the input. Carefully and neatly sketch the resulting output, including numeric values, of output volt..

  Implement the logarithm circuit using the given rom

Design a logic circuit, LOGARITHM that converts an input number X to its logarithm, log(X). Input X is given as an unsigned real number such that, 1.00

  What is rotating speed in rpm for a 4-pole induction machine

The stator frequency of an induction machine is 50 Hz and the rotor circuit frequency is 5 Hz. What is the rotating speed in rpm for a 4-pole induction machine

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd