Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The part in Problem 33.1 is to be fabricated using fused deposition modeling instead of stereolithography. Layer thickness is to be 0.20 mm and the width of the extrudate deposited on the surface of the part = 1.25 mm. The extruder workhead moves in the x-y plane at a speed of 150 mm/s. A delay of 10 s is experienced between each layer to reposition the workhead. Compute an estimate for the time required to build the part.
Problem 33.1
A prototype of a tube with a square cross section is to be fabricated using stereolithography. The outside dimension of the square = 100 mm and the inside dimension = 90 mm (wall thickness = 5 mm except at corners). The height of the tube (z-direction) = 80 mm. Layer thickness = 0.10 mm. The diameter of the laser beam (‘‘spot size'') = 0.25 mm, and the beam is moved across the surface of the photopolymer at a velocity of 500 mm/s. Compute an estimate for the time required to build the part, if 10 s are lost each layer to lower the height of the platform that holds the part. Neglect the time for postcuring.
determine the radius of the crank r and the speed n of a slider crank mechanism used in a shaker table. it is required
Using the force flow con- cept, locate the critical sections and/or surfaces for the container.
This provides an acceptable bolt spacing. What load factornresults from this selection?
a flat plate solar collector 6 ft by 12 ft is mounted on the roof of a house. the outer surface of the collector is at
The rotor speed is 2000 r/min, and the armature voltage is 100 V. The armature resistance is 2 Ω and R f = 200 Ω . Calculate the no-load rotor speed.
Does a heat engine that has a thermal efficiency of 100 percent necessarily violate?
A cantilever beam with a 1 in diameter is loaded at the tip with a transverse force of 1000 lb. Figure 2.1 below shows the beam configuration and cross-section with points A at the top, point B at the center and point C at the midpoint between A and ..
Find the shear flow acting in each web/skin segment in the structure. As part of your final answer, in a sketch, clearly illustrate the resultant shear flow acting in each segment of the wall indicating its numerical value and direction.
a.calculate the enthalpy entropy and gibbs free energy changes when 10g of supercooled liquid silver solidifies
Suppose one of your classmates claims that the following boolean expressions represent the conversion from 4-bit Gray code to 4-bit binary numbers:
Your task is to find a structure / machine that has some biological component to it from the world of nature or sports and analyse it using math based equations.
A system consists of two blocks, of masses m and 2m, attached to the ends of a mass less spring with a force constant k. The system is placed on a horizontal friction-less surface. Initially, the spring is relaxed. The blocks are then pulled apart an..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd