Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The table below gives physical properties for three types of fibers used to reinforce polymer resins to make PMC materials.
FIBER TYPE>> CARBON ARAMID E-GLASSModulus of Elasticity- MSI 33 18 10.5Tensile Strength- KSI 580 400 500Specific Modulus of Elasticity- MSI 18.3 12.5 4.1Specific Tensile Strength- KSI 322 278 197Specific Gravity- g/cc 1.8 1.44 2.54Relative Cost High Moderate Low
MSI = million lb/in2KSI = thousand lb/in2
Compare these fibers as the reinforcing material in PMC materials. In what types of applications might you chose each of them, keeping in mind stiffness, strength, density and cost factors? A thorough discussion is expected.
the temperature of a flowing gas is to be measured with a thermocouple junction and wire stretched between two legs of
steam at 2.5 mpa and 400 c enters an adiabatic steam turbine with a low velocity and leaves with a velocity of 180 ms
hot air steadily enters a gas turbine at 5 bar 900 k and exits at 1 bar 600 k and a velocity of 100 ms. the mass flow
image text transcribed for accessibility a black thermocouple is used to measure the internal temperature of a furnace
the greatest fluctuation of energy to be stored by an engine flywheel is 2kj when the mean engine speed is 4 revs. the
refrigerant 134a at 1mpa and 90 degrees c is to be cooled to 1 mpa and 30 degrees c in a condenser by air. the air
an effluent stream consists of poly-dispersed aerosol of uniform density 1.8 gcm3. the particle size distribution is
a small radiant heater has a metal strips 6 mm wide with a total length of 3 m. the surface emissivity of the strips is
methane escapes through a small 10-7 m2 hole in a 10-m3 tank. the methane escapes so slowly that the temperature in the
if the volume of a bucketful of water is described by the normal distribution with a mean of 2.7 gallons and a standard
part a.the slender bar ab rests on a smooth surface at b and is attached to a collar a that slides freely on the smooth
a heat exchanger is to cool ethylene glycol cp 2.56 kjkg degree c flowing at a rate of 3.2 kgs from 80 degree c to 40
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd