Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A power cycle operate between hot and cold reservoirs at 600k and 300k, receptively. At steady state the cycle develops a power output of .45MW while receiving energy by heat transfer from the hot reservoir at the rate of 1MW.
(a) Determine the thermal efficiency and the rate at which energy is rejected by heat transfer to the cold reservoir, in MW.
(b) Compare the results of part (a) with those of a reversible power cycle operating between these reservoirs and receiving the same rate of heat transfer from the hot reservoir.
the 50-kg crate is now projected down an incline as shown with an initial speed of 7 ms. investigate the time t
helium at 810 r 45 ibfin2 and a velovity of 10 fts enters an insulated nozzle operating at steady state and exits at
a cylinder fitted with a piston contains 5 lbm of saturated liquid water at 300 lbfin2. heat is slowly transferred to
A Brayton gas turbine cycle has two stages of compression and two stages of expansion. The pressure ratio across each stage of the compressor and turbine is 3. The air enters each stage of the compressor at 300K and each stage of the turbine at 1..
The velocity at the inlet is controlled so that it changes according to the following expression. V=a-ct^2, where a = 20m/s, c- 0.8m/s. If the tank initially contains 3kg of liquid water, determine the final mass at the end if 4 seconds of flow.
a curved nozzle assembly that discharges to the atmosphere is shown. the nozzle mass is 4.5 kg and its internal volume
blocks a and b weigh 25 lb and 10 lb respectively and they are both at a height 6 ft above the ground when the system
refrigerant 410a is used for a heat pump. the temperature at the evaporator is -20f. the temperature at the exit of the
a six cylinder diesel engine with a 4.5 inch. bore for each cylinder and 5.0 inches stroke works on a theoretical
Assuming that the air is 80°F and 1 atm and blows across the wall as on a flat plate, estimate the average temperature the wall will attain for equilibrium conditions.
determine the average applied force exerted on to the pile hammer. Note because the force is applied over a short time period it can be considered as an impulse force.
a rigid vellel with the volume of 10 m3 contains a water-vapor mixture at 400 kpa at 60 percent quality. the pressure
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd