Compare the resulting quantization snr in db for all cases

Assignment Help Electrical Engineering
Reference no: EM13227180

Generate a sine wave signal with amplitude A=1, and frequency=0.1592Hz. Using a uniform PCM method, quantize it ot a) 8-level and b) 16-level. Plot the original signal and the quantized signals on the same axes (time duration=10 sec). Compare the resulting quantization SNR in dB for both cases.

Reference no: EM13227180

Questions Cloud

Principles of a successful non-compete agreement : Draft a valid non-compete agreement that can be used by the parties should Bobswell part ways with the company. Explain each clause and why it is reasonable under the principles of a successful non-compete agreement.
Explain the rights and liabilities of the bailor and bailee : In this hypothetical case study, you will evaluate whether a bailment relationship exists, and if so, explain the rights and liabilities of the bailor and the bailee.
What will the new volume of the bag at constant pressure : On hot days, you may have noticed that potato chip bags seem to inflate even thougt they have not been opened. if i have a 250 mL bag at a temperature of 19 C and i leave it in my car that has a temperature of 60 C, what will the new volume of the..
Determine what is the minimum sampling frequency : a) What is the minimum sampling frequency b) Specify the number of uniform quantization steps needed and the channel null bandwidth required, assuming that the peak signal-to-noise ratio at the receiver output needs to be at least 30 dB
Compare the resulting quantization snr in db for all cases : Generate a sine wave signal with amplitude A=1, and frequency=0.1592Hz. Using a uniform PCM method, quantize it ot a) 8-level and b) 16-level. Plot the original signal and the quantized signals on the same axes
Write the code for the delay procedure : We would like to monitor the first two least significant bits of PORTB (use masking technique). Whenever both of these bits are set, switch all LEDs of Port A on for one second. Assume that the name of the delay subroutine is DELAY.
Describe the products goods and services : China and India have demonstrated trends toward Western-style consumption over the last decade. Given the emphasis on the youth market in the US over the last 60 years (since the baby boom), what can you suggest for marketers in these youth-orient..
Analyze the case and assess the banks obligation : Analyze the case and assess the banks obligation and Sam's claim and a bank advertises home loans at low interest rates for its account holders for three months.
Explain strength of intermolecular forces : Place the following compounds in order of increasing strength of intermolecular forces. CH4, CH3CH2CH3, CH3CH3

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What environmental factors should you consider

You do some quick measurements and find that the area of the lagoon behind the dam would be about 5m wide by 20m long, and the lagoon would be about 3m deep at high tide, and 1m deep at low tide.

  Calculate the electron

A new semiconductor has Nc = 1019 /cm3 and Nv=5 x 1018, and Eg = 2eV. If it is doped with 1017 donors (fully ionized), calculate the electron, hole, and intrinsic carrier concentrations at 627K.

  Calculate the voltage and the current at transmitting end

A 60-Hz, single-phase transmission line has a length of 80 miles. Its shunt conductance (G) is 3.4A1011 S/mile, resistance (R) is 0.1 OHMS/mile, capacitance (C) is 16 pF/mile, and inductance (L) is 0.56 mH/mile.

  Calculate the resistors resistance

calculate the resistor's resistance. If the bandwidth were cut to 25 kHz, determine the expected output meter reading.

  Find the charge on the capacitor

the circuit has been connected for several seconds, find current in (a). in the 4.00 volts battery, (b). in the 3.00 ohm resistor, (c). in the 8.00 volts battery, (d). in the 3.00 volts battery and (e). find the charge on the capacitor?

  Find the maximum acceleration that can be measured

An LVDT (Linear Variable Differential Transformer) is used in an accelerometer to measure seismic-mass displacement. The LVDT and signal-conditioning output is 0.31 mV/mm with a +/- 2 cm maximum core displacement.

  Draw the sympol and truth table of the gate

draw the sympol and truth table of the gate that corresponds to the action of the logic gate.

  Define important information about electrical networks

Important information about Electrical Networks, Engine consumes 5kw of power and a reactive power of 2kvar at current of (3+j2) Amps.

  A circuit contains two devices that are connected

A circuit contains two devices that are connected in parallel. If the resistances of one of these devices is 12ohms and the resistance

  Define frequency divider

Important information about Frequency Divider, Design a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input

  Which one will store most charge

For a circuit with resistor of 10 K ohm and a capacitor of 5 micro Farads, what is the time constant in second?

  Determine the peak current during discharge

A person shuffling across a dry carpet can be approximately modeled as a charged 100-pF capacitance with one end grounded. If the person touches a grounded metallic object such as a water faucet, the capacitance is discharged

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd