Compare the capacities of the fiber and conducting cables

Assignment Help Electrical Engineering
Reference no: EM13219354

A fiber telephone cable contains 144 fibers, each capable of carrying 672 voice messages. A conducting telephone cable contains 900 copper twisted pairs, and each pairs can carry 24 messages. Compare the capacities of the fiber and conducting cables. How many of the conducting cables are required to equal the capacity of the fiber cable.

Reference no: EM13219354

Questions Cloud

Draw the gate-level diagram : Write the logic equation for Y in terms of A,B,C that solves this problem, and draw the gate-level diagram.
What is the per-phase current : A three-phase substation transformer operating at 34.5kV is loaded to 24 MVA. What is the per-phase current? (assume balanced conditions)
Estimate of the maximum fundamental operating frequency : Using the LM555 data sheet, make an estimate of the maximum fundamental operating frequency in the astable mode.
Derive an expression for the incremental work : A positive charge of magnitude q1 lies at the origin. Derive an expression for the incremental work done in moving a second point charge q2 through a distance dx from the starting position (x, y, z) in the direction -ax.
Compare the capacities of the fiber and conducting cables : Compare the capacities of the fiber and conducting cables. How many of the conducting cables are required to equal the capacity of the fiber cable.
Why hyperinflation has such a devastating impact n economies : Explain why hyperinflation has such a devastating impact n economies. Explain what it takes to stop hyperinflation Describe the three types of unemployment. What types of government programs would be most effective in combating each type of unempl..
How to design boost converter and inverter parameters : how to design boost converter and inverter parameters?
Determine the left triceps muscle force : Determine the left triceps muscle force (Ftri), elbow joint reaction force (Rj) required to hold this position along with any ground reaction forces (Rg) and/or reaction moments (Mg) in the hand. Show all necessary free body diagrams along with th..
What is the voltage induced : A coil of 2000 turns surrounds a flux of 5 mWb produced by permanent magnet. The magnet is suddenly withdrawn causing the flux inside the coil to drop uniformly to 2 mWb in 1/10 of a second. What is the voltage induced.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Solve general questions for network communications

General questions for network communications, A user message is split into 15 frames, each of which has an 80% chance of arriving error-free. If no error control is used by the data link layer, how many times must the message be sent on the averag..

  Explain what rf bandwidth must the radio link provide

What RF bandwidth must the radio link provide if the modulation is binary phase shift keying (BPSK)?

  What charge must be on each plate

An electric field of 3.10×105 is desired between two parallel plates, each of area 36.0 and separated by 0.620 of air.What charge must be on each plate?

  Line a goes into an inverter then into a nand gate

Simplify the following circuit. Line A goes into an INVERTER, then into a NAND Gate, then into an OR Gate, then travels into another NOR Gate.

  Efficiency of mosfet circuit

Efficiency of MOSFET circuit provide in datasheets of any product is measured at transient state of my output node or staedy state?

  Define tune pi parameters

Tune PI Parameters, Question: Given are the facts that Gc and Gp(s) are in series and Gp(s) = (K * Km) / [s[(Ls+R)(Js+b) + K^2m)]].

  Find the output voltage produced

A 6-bit DAC has an input 1001012 and uses a 10.0-V reference.

  Calculate the output resistance of the device

Calculate the output resistance of the device, dIC/dVC, for 0

  Find zo of line

when the line was open-circuited, the measurement yielded an input impedance equivalent to a capacitor with capacitance of 40 pF. Find Zo of line, the phase velocity, and the relative permittivity of the insulating material.

  Calculate the average torque and maximum torque

When the two windings are connected to a a.c supply of 50hz, the field current is 0.1A, the armature current is 100A and the phase difference between them is 60 degree. calculate the average torque and maximum torque.

  Consider a chip design using mask levels

Consider a chip design using 10 mask levels. Suppose that each mask can be made with 98% yield. Determine the composite mask yield for the set of 10 masks.

  Find the normal force exerted by the pavement on the tires

A curve of radius 159 m is banked at an angle of 11°. An 810-kg car negotiates the curve at 93 km/h without skidding. Neglect the effects of air drag and rolling friction. Find the normal force exerted by the pavement on the tires.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd