Compare a lumped element model of a lossless transmission

Assignment Help Electrical Engineering
Reference no: EM13138906

Comp transmission line lumped element vs distributed model
Compare a lumped element model of a lossless transmission line (single L and C) with the distributed model. Use the following values for the transmission line in this comparative analysis.

Vg = 5 V
Zg = 50 ohms
L' = 100 nH/m
C' = 100 pF/m
ZLoad = 100 ohms

For the lumped model, represent the entire line by L = L' l, C = C' l, etc. and solve for VLoad using standard circuit analysis techniques.

For the distributed model, use the transmission line equations for Zo, Reflection coefficient (r), Zin, Vo+ and VL.

For both cases, express the equations in terms of l/lambda. Please show the derivation of the equations used.

Reference no: EM13138906

Questions Cloud

How formula requires knowing population standard deviation : There is not enough information to answer the question, the formula requires knowing the population standard deviation for Mark and Debbie, and we were not given this information.
How would consolidated cost of goods sold have differed : How would consolidated cost of goods sold have differed if the inventory transfers had been for the same amount and cost, but from Stendall to Edgar?
Block diagram and equations for control system water fill : Block diagram and equations for control system water fill, Develop a control system to fill a container with water after it is emptied through a stopcock at the bottom
What was consolidated cost of goods sold : Rand still owned 40% of the goods at the end of the year. Cost of goods sold was $10,800,000 for Webb and $6,400,000 for Rand. What was consolidated cost of goods sold?
Compare a lumped element model of a lossless transmission : Compare a lumped element model of a lossless transmission line (single L and C) with the distributed model. Use the following values for the transmission line in this comparative analysis.
Management is the effective utilization of human material : management is the effective utilization of human material resources to achieve the enterprise objectives ,comment.
Explain why the amount of net income differs from the amount : What amount of net income would Spartan Company report on its 2010 income statement? Explain why the amount of net income differs from the amount of the ending Retained Earnings balance.
Opportunity to students to investigate : This assignment gives the opportunity to students to investigate new area of study totally related to consumer behavior theories but happened in the real life and to fully understand why we need to understand consumers.
What percentage of calls are longer than thirty five minutes : A standard deviation of five minuts. Assuming the call times are normally distributed, what percentage of calls are longer than 35 minutes.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Ziegler-nichols open loop tuning

Ziegler-Nichols Open Loop Tuning Often, when working with a faster loop, many people will opt only for a PI control philosophy

  Explain a terrestrial radio link transmits a cdma signal

A terrestrial radio link transmits a CDMA signal from a base station using a spreading code with a chip rate of 1.0 Mchips per seconds. The message data rate of the signal is 10 kbps.

  Analyzing the blink alive code

Analyzing the Blink Alive code - Embedded Systems Design

  Define the gain of the antennas must be increased

The gain of the antennas must be increased when the TDMA system described in part (d) is used because the bit rate is higher than with FDMA and the noise power in the receiver is therefore higher

  Determine ideal impulse response using inverse discrete-time

Determine ideal impulse response using inverse discrete-time Fourier transform. An ideal low-pass filter is described in the frequency-domain by

  What local oscillator frequency would you use

For the local oscillator you selected, what transmission frequencies could cause interference to the satellite system and how could the interference be avoided? Show a diagram.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Finding peak amplitude and frequency

Finding peak amplitude, frequency, and spectrum shape, b. A signal generator outputs a unipolar square wave with a period of 0.50 ms and an amplitude of 2.0 V. The output of the generator is passed through an ideal band pass filter that has a pass..

  What is the quantization signal to noise ratio snrq

What is the quantization signal to noise ratio SNRQ at the receiver output? e. If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?

  Define what is the channel capacity for a channel

What is the channel capacity for a channel with a 300 Hz bandwidth and as S/N = 3? 2nd problem: Given a channel with a 50 kHz bandwidth and a S/N = 127, determine:

  Fdtd evaluation of the sar distribution

Finite Difference Time Domain (FDTD) numerical method to develop for me a software program that simulates - evaluates Specific Absorption Rate (SAR) Distribution in a Human Head Near a Mobile Cellular Phone as a student project.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd