Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A simple truss. The 3-member truss is supported by a pin at joint A and a roller at joint C. There is a load P (in Newtons) being applied at joint B in the positive horizontal direction. The following equations describe the reaction forces at joints A and C as well as the member forces (FAB, FAC, FBC):
Write a MatLab program that does the following:• Prompts the user to input a positive value of P• Determines if the member forces are in tension or compression (note that a negative number denotes compression and a position number denotes tension)• Calculates and displays the reaction and member forces• Asks the user if they would like to continue and enter a new value• Quits the program if the user answers no
The output should look like the following:
For the input value of 500NAx = 500 N (to the left)Ay = 500 N (downward)Cy = 500 N (up)Fbc = 707.1 N (Compression)Fab = 500 N (Tension)Fac = 500 N (Tension) Would you like to run the calculation again with a different input value?
what is the velocity of the cart when the bullet becomes embedded int he terget? during the firing, the man remains at the same position on the cart. neglect rolling resistance of the cart.
Determining the Exit Temperature and Power Input of Air through a Compressor, Air at 150Pa and 310K enters a compressor of inlet diameter 2cm. The Compressor raises the pressure to 3.5 times the inlet pressure
In the gear-and-shaft system shown, the shaft diameters are dab= 2 in. and dcd=1.5 in. Knowing that G = 11.2 x10^6 psi, determine the angle through which end d of shaft cd rotates.
Explain the first law of thermodynamics using the conversion of a fuel (gasoline or diesel) in an internal combustion engine. Provide sufficient details (sentences and illustration) to explain the first law.
locate the initial and final states on a sketch of the T-v digram. determine the mass of vapor present at the initial and final state, each in kg.
The heat transfer coefficient in the oven is 25W/m^2K. Calculate rate of heat transfer per m^2 area.
The 25-kg bar has a centre of mass at G.If it is supported by a smooth peg at C,a roller at A and cord AB, determine the reactions at these supports.
Design of absorption column and the cooler. Process design of other units should be completed along with pipe sizes.
Principles of Engineering Economic Analysis-Time value of money-use of gradient factor is expected
If water leaves the basement at 88C, determine the rate of heat loss from the weather.
why is the carnot cycle not suitable as an ideal cycle for all the power producing devices ?
Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd