Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a 300W PFC BL-Zeta converter operating in DCM (Output Inductor) to maintain a DC link voltage of 100V with percentage ripple of 4%. The permitted ripple in the input side inductor and intermediate capacitor is given as 20%. The PFC converter is to be operated at 220V/50Hzinput with switching frequency as 40kHz. The turns ratio is given as 2:1.
Calculate the value of input and output inductors, intermediate capacitor and the DC link capacitor ?
What is the effective data rate of this transfer (not counting the time for reading or writing the DVDs)?
What is the BER at the output of the receiver in clear air conditions, and the average time between errors? Give your answer in years, days, or hours as appropriate. Assume an implementation margin of 0.5 dB.
A network connected between terminals a and b consists of two parallel combinations that are in series. The first parallel combination is composed of a 10-phm resistor and a 15-ohm resistor. The second parallel combination is composed.
MOSFET Amplier Sketch the 4-resistor bias network for an amplier with an n-channel enhancement-mode MOSFET, with R1 = 1Mohm ; R2 = 1:5Mohm ; RD = 75kohm ; Rs = 39kohm ; K = 25microA/V2 ; VDD = 10V and Vto = 1V.
Determine the initial stored charge. Determine energy of the capacitor. If this capacitor is discharged to 0 V in a time interval of 1 s, find the average power delivered by the capacitor during the discharge interval.
What is the power level entering the first active stage of the receiver at 1900 MHz being fed by a 25 meter coax with a loss of 20 dB/km, given that the Isotropic Receive Level is -134 dBW and the receiving station has a 1 meter radius dish
A 150MW alternator generates an open-circut line-t0-line voltage of 12kV at nomial DC excitiation. When the terminals are placed in short-circuit the resulting current per phase is 8000A. a) Calculate the approximate value of the synchronous reacta..
An electric heating element is connected to a 110 v circuit and a current of 3.2 A is flowing through the element. How much energy is used up during a period
Calculate the percentage second harmonic distortion present in the output. Calculate the percentage error in the output voltage compared to its ideal value at the instant of time when t= 1/3200 seconds.
Create a block diagram of the electronics of the proposed vehicle. Include enough detail on each components and number of wires between each subsystem.
I)Design a circuit that gives you the following relation between input and output Vout = 2.17Vin + 5 Here are the constraints you need to work with: 1) Only one power supply that gives ±12V is available 2) Available op-amps run on ±12V
A filter has the following characteristics: Attenuation is 0 dB from 0 Hz to 2.5 kHz. Phase angle decreases linearly with increasing frequency above 2.5 kHz. Above 5 kHz the filter has steadily increasing attenuation.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd