Calculate the total number of kbps needed in the adc

Assignment Help Electrical Engineering
Reference no: EM13254704

An analog signal has a bandwidth of 37 kHz and must be digitized in an ADC. The peak voltage is 7V and you need to maintain a resolution of 0.078V. Find the number of bits per sample and then calculate the total number of kbps needed in the ADC.

Reference no: EM13254704

Questions Cloud

Analyze 14th amendment which claims equal protection : What are the three level of scrutiny used to analyze 14th amendment which claims equal protection?
Which is the maximum noise allowed in the receiver : A radio link receiver has a signal sensitivity of 100 milliwatt. The SNR required is at least 14 dB. Which is the maximum noise allowed in the receiver.
The phosphate ion forms insoluble precipitates with calcium : The phosphate ion forms insoluble precipitates with calcium and magnesium ions, removing them from solution. Suppose that a solution is 4.5×10?2 in calcium chloride and 8.5×10?2 in magnesium nitrate.
Develop an objective analysis : The missing piece we need is Earned Value (i.e. what we have actually accomplished so far). You meet with your team and find that only 6 of the 7 tasks scheduled to be complete by the end of month 4 have actually been completed.
Calculate the total number of kbps needed in the adc : An analog signal has a bandwidth of 37 kHz and must be digitized in an ADC. The peak voltage is 7V and you need to maintain a resolution of 0.078V. Find the number of bits per sample and then
Explain lightning from thunderstorms strike the earth : Lightning from thunderstorms strike the Earth 100 times each second. 2400 deaths have been caused by lightning strikes over the past 25 years. How many strikes occur before a death occurs
What is the density of the fluid : A rectangular metal block is 0.6 m long, 0.2 m wide, and 0.1 m tall. The block weighs 270 N. What is the density of the fluid
Develop a master production schedule for the breadmaker : Develop a master production schedule for the breadmaker. What do the projected ending inventory and available-to-promise numbers look like? Has Realco "overpromised"? In your view, should Realco update either the forecast or the production numbers..
Prepare a partial income statement : Prepare a partial income statement for 2013 beginning with income from continuing operations. Ignore EPS disclosures. Prepare a partial income statement for 2013 beginning with income from continuing operations. Assuming that the estimated net fair v..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is signal to noise ratio at the output of the amplifer

Assume you have a receiver with an overall noise figure of 23 dB and a bandwidth of 1 MHz. Assuming the minimum acceptable SNR at the output of the receiver is 6 dB, estimate the minimum detectable signal level in dBm at the receiver input.

  Determine the maximum and minimum spectral frequencies

Determine the maximum and minimum spectral frequencies received from a stationary GSM transmitter that has a center frequency of exactly 1950.000000 MHzassuming that the receiver is traveling at speeds of.

  Find out the frequency response of receptor

Determine the frequency response of this receptor to stretching. There are devices that can apply sinusoidal stretch to a small segment of tissue.

  Find the power being absorbed

A current source of 12 cos 2000t A, a 200-ohm resistor, and a 0.2-H inductor are in parallel. Assume steady-state conditions exist. At t = 1 ms, find the power being absorbed by the (a) resistor; (b) inductor; (c) sinusoidal source.

  Find the normalized voltage magnitude values at the load

You are to specifically find the normalized voltage magnitude values at the load plane and the voltage maxima and minima points on the line and 9 additional points which are spaced at intervals of 0.05 ohm from the load plane, i.e., at a total of ..

  What are the equivalent admittance and conductance

Three branches having impedances of 3 + /4 O, 16 - /12 ft, and - / 4 ft, respectively, are connected in parallel. What are the equivalent (a) admittance, (b) conductance, and (c) susceptance of the parallel connection in millisiemens

  Determine the conductivity of silicon at t

Determine the conductivity of silicon at T = 300 K if it is doped with donor impurity atoms at a concentration of 1.25*1016 cm-3. Assume that the electron and hole mobilities are 1350 cm2 / V-s and 480 cm2 / V-s, respectively.

  What is the most common used op-amp in the industry

1) What are some practical op-amp applications Can you give example and explain why the bop-amp was used in your example 2) What is the most common used op-amp in the industry

  What is an alternative to using a higher order anti-aliasing

1. A transfer function of a low pass filter may be divided into which three response ranges Actual response, ideal response, and straight-line response Gain, ripple, and roll-off Pass band, roll-off, and stop band Attenuation, gain, and roll-off

  What is voltage present after ten second delay

In a power supply, a 150 microfarad capacitor was connected in parallel with a 200 kOhm resistor. The capacitor was maintained at a charge level of 350 volts DC. After power was removed for ten seconds, someone god a shock from touching the termin..

  What role does im/it enablement play

By that I mean, how does IM/IT help KL carry out day-to-day operations and transacting, how does it aid management processes, and does it enable KL product and service innovation?

  Find equivalent impedance of transformer of low-voltage

A 3-phase 230 V, 9 kVA, 0.9 PF (lagging) load is supplied by 10 kVA, 1330/230 V, 60 Hz three-phase transformer connected in Y-?. The equivalent impedance of transformer referred to the low-voltage side is 0.12 + j0.25.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd