Calculate the standard deviation of the slope and intercept

Assignment Help Mechanical Engineering
Reference no: EM131083568

The method developed in Problem 14-11 was used for the routine determination of iron in 25.0-mL aliquots of groundwater. Express the concentration (as ppm Fe) in samples that yielded the accompanying absorbance data (1.00-cm cell). Calculate the relative standard deviation of the result. Repeat the calculation assuming the absorbance data are means of three measurements.

2308_d2c1d96d-1143-42b7-ad92-36a70ab01cd1.png

Problem 14-11

A standard solution was put through appropriate dilutions to give the concentrations of iron shown below. The iron(II)-1,10,phenanthroline complex was then formed in 25.0·mL aliquots of these solutions, following which each was diluted to 50.0 mL. The following absorbances (1.00-cm cells) were recorded at 510 nm:

2157_c97f5c85-fbdb-450e-a72b-fd976ef7a822.png

(a) Plot a calibration curve from these data.

(b) Use the method of least squares to find an equation relating absorbance and the concentration of iron(II).

(c) Calculate the standard deviation of the slope and intercept.

Reference no: EM131083568

Questions Cloud

Find the molar absorptivity of the complex : Find the molar absorptivity of the complex.
Fixed cost of production and average cost of production : Suppose you are the owner of a pizza restaurant operating in a competitive market. Your cost of production is given by TC (Q)= 500+9Q-7/2Q^2+1/3Q^3, where q is the number of pizzas and TC is the total cost. What is the variable cost of production, fi..
Difference between the opening bell and closing bell prices : Over the course of a day, the stock price of a widely traded company can be modeled as a Brownian motion process where X(0) is the opening price at the morning bell.
External rate of return from switching to reclaimed water : Suppose that Dr. Stone brewery could use recliamed municipal water waste water to make beer instead of the municipal water that is currently being used. this will help conserve limited fresh water resources and reduce the brewery's annual water bill...
Calculate the standard deviation of the slope and intercept : Calculate the standard deviation of the slope and intercept.
Tend to have lower price elasticity of demand : Select all of the following that would tend to have lower price elasticity of demand.
If an economy is producing inefficiently : If an economy is producing inefficiently, it is
Irrational behavior on three levels that caused the crisis : To this end how could the Mortgage crisis of the 2000's been avoided if the market was truly efficient and highlight the irrational behavior on three levels that caused the crisis.
Mention communication problems in company : For example, you can constructcommunication problems for the company, even though the scenario above does notspecifically mention communication problems in the company. Or you can construct hiringproblems and weaknesses if you would like to.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Package design

Package Design Brief: Assume you are the packaging engineer for a large consumer products company. In this company, the Packaging Design Briefs are initiated by the marketing group and forwarded to the Package Engineering group.

  Mechanical engineering questions

Define dynamic viscosity, Determine the centroid, Pressure due to the height of liquid, Advantage of changing the liquid, Calculate the total moment about the hinge of the seal gate.

  Automatic control

DOF system and Find the differential equation describing the system

  Write a paper on boyle''s law

Write a paper on Boyle's law and describe Compression and Combustion stroke . Also explain Charles's law and illustrate SI engine and CI engine.

  Verify the law for parallelogram of forces

To Verify the law for parallelogram of forces, law for triangle of forces and law of polygon of forces. These laws are very useful to calculate unknown forces in very short time.

  Discharge pressure of the compressor

What is the discharge revised discharge pressure of the compressor.

  The Case for Global Accounting Standards

The role of IFRS in both developing and developed capital markets.

  Wind turbine

Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.

  Advanced design methodologies

8 x product engineering and design review (week 2 – 12), ~3 pages per item which must contain a brief description of the product then delve into concepts such as materials selection, manufacturing methods, life cycle analysis, recyclability and overa..

  Design of absorption column and the cooler

Design of absorption column and the cooler. Process design of other units should be completed along with pipe sizes.

  Determine the maximum total bending moment

Determine maximum total bending moment (static plus dynamic) of the beam under steady-state conditions.

  Force of the water on the gate

Determine the magnitude of the horizontal and vertical components of the force of the water on the gate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd