Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Two dc motors are compared. the first one is a 4hp dc motor which draws a current or 0.7A when the field is connected to a 150V source. the second, a 600 hp motor draws a field current of 5A when the field is connected to a 300V dc source. calculate the power required for the field as a percentage of the rated power of the motor. what is the main difference between the two cases?
The system uses a 7-cell reuse pattern. If the offered traffic per user is 0.03 Erlangs and the average number of calls per hour per user is 1.5, for an Erlang-C system with a probability of delaying a call being 5%, calculate the traffic load per..
Compare the by hand solution and the PSPICE simulation for a voltage amplifier which has an input resistance of 10kohms and an output resistance of 100ohms, and a gain of 100V/V. The voltage amplifier is capacitively coupled to a voltage source.
Deer ticks can carry both Lyme disease (L) and human granulocytic ehrlichiosis (H). In a study of ticks in the Midwest, it was found that 16% carried L, 10% carried H and 25% that had either L or H carried both.
A balanceed three-phase load of 15 MA with a lagging load factor of 0.85 is supplied by a 115KV subtransmission line. if the line impedance is 50+j100Ohm per phase, determine the following: (a) The line current of the load
c) Find the output y(t) in response to the input x(t) = 6 u(t), where u(t) is the unit step function. d) Find the output y(t) in response to the input x(t) = δ(t) A linear system has the system response function H(s)= -7/(s+4)
1. Find the volume of a frustum of a pyramid with square base of side 17, square top of side 9 and height 14.2. The base of a solid is a circular disk with radius3. Parallel cross sections perpendicular to the base are squares.
An ultrasound image analog signal needs to be converted to a digital bit stream. The bandwidth of the signal is from 500 kHz to 2.0MHz, and the necessary resolution is 12 bits. determine the required sampling rate and the data rate
Draw the per-phase impedance diagram of the power system and Draw the impedance diagram in per-unit system
Based on these equations, determine the maximum power point. This is the value of and T that result in maximum power. State the power and the (,T) values. Do not assume this happens at 0.5T. The best way to do this is to make an Excel spreadsheet.
A Si (ni = 1 e+10 cm^-3, eps = 11.7) p-n junction is doped with NA = 5.2 e+18 cm^-3 and ND = 8.4 e+14 cm^-3. What reverse bias (the absolute value) should be applied to the junction, in order to achieve the maximum electric field of 3.89E+4 V/cm
A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.
A GPS receiver located at ground level simultaneously detects signals from three ground-based transmitters. The first signal, originating from Shenandoah University in Winchester, is decoded to read "the time is 10:12:07.612040".
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd