Calculate the power output of the turbine the fraction of

Assignment Help Mechanical Engineering
Reference no: EM13617304

A large stationary Brayton cycle gas-turbine power plant delivers a power output of 100000 hp to an electric generator. The minimum temperature in the cycle is 540 R, and the exaust temperature of 1350 R. The minimum pressure in the cycle is 1 atm, and the compressor pressure ratio is 14 to 1. Calculate the power output of the turbine, the fraction of the turbine output required to drive the compressor and the thermal efficiency of the cycle?

Reference no: EM13617304

Questions Cloud

A stock is expected to pay a 100 dividend per share the : a stock is expected to pay a 1.00 dividend per share. the growth rate is expected to be 4. if investors demand 10 on
A firm has been losing sales due to technological : a firm has been losing sales due to technological obsolescence. it projects growth for the future to be -2. its recent
A particle has a velocity u 059c in the labortory the : a particle has a velocity u 0.59c in the labortory. the laboratory is itself moving with velocity v 0.81c relative to
A particle has a velocity u 084c in the labortory the : a particle has a velocity u 0.84c in the labortory. the laboratory is itself moving with velocity v 0.77c relative to
Calculate the power output of the turbine the fraction of : a large stationary brayton cycle gas-turbine power plant delivers a power output of 100000 hp to an electric generator.
The company has 200000 loan outstanding from local : the company has 200.000 loan outstanding from local community bank. the interest rate on the loan is 11.5 fixed.
A loss x this year has the pdf fx 21x-3 xgt0 zero : a loss x this year has the pdf fx 21x-3 xgt0 zero otherwise. next year the loss will increase by 20. next year a
Two spaceships pass each other travelling in opposite : two spaceships pass each other travelling in opposite directions. the speed of ship b as measured by a passenger in
The adjusted trial balance of pacific scientific : the adjusted trial balance of pacific scientific corporation on december 31 2013 the end of the companys fiscal year

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the enthalpy change of the universe

calculate the enthalpy change of the universe during the process. Cp=Cv = 4.18 kj/kgK

  The specific humidity on leaving is decreased to one-third

an air-water-vapor mixture enters a cooler-dehumidifier at the rate of 1000 ft3min. the mixture enters at 14.7 psia

  Calculate the constant acceleration a that the car must

a train which is traveling at 80 mihr applies its brakes as it reaches point a and slows down with a constant

  The total pressure of air entering a single-stage

the total pressure of air entering a single-stage centrifugal compressor is 1.013 bar and the total t is 288 k. the

  What is the elastic modulus of elasticity

a standard steel specimen of 13 mm diameter elongated 22 mm when it was subjected to a tensile force of 29.5 kN if the specimen has a length of 200 mm and that force applied within elastic range. what is the elastic modulus of elasticity ?

  Water flows 2m deep at 2ms in a rectangular channel find

water flows 2m deep at 2ms in a rectangular channel. find the change in depth and in water surface elevation caused by

  Finally it comes to a stop in one half a rotations what was

a 50 kg winding drum 75 cm in diameter is used to reel in cable. it is moving at the rate of 2 revolutions per second.

  The can diameter and height are d 65 mm and h 120 mm the

a partially full can of soft drink is placed at the outer edge of a childs merry-go-round located r 1.5 m from the

  Determine the maximum shear stress

Draw the Mohr's circle for this stress state, deterrnine the principal stresses and the angle of the principal direction to the x-axis and determine the maximum shear stress.

  What is the density of liquid al-116si alloy at the melting

what is the density of solid aluminum at the melting temperature? what is the density of liquid aluminum at the melting

  Diameter sphere is embedded in insulation

A 4 m diameter sphere is embedded in insulation. The sphere contains a liquid-ice mixture maintained at 0 deg C. The ambient temperature surrounding the insulation is 25 deg C.

  A painter is standing on a work platform that is 27 feet

a painter is standing on a work platform that is 27 feet above ground level. for fall protection the workers safety

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd