Calculate the maximum shear stress tmax on cross section

Assignment Help Mechanical Engineering
Reference no: EM131062384

Shear Stresses in Wide-Flange Beams

A simple beam of W 10 × 30 wide-flange cross section supports a uniform load of intensity q = 3.0 k/ft on a span of length L = 12 ft (see figure). The dimensions of the cross section are h = 10.5 in., b = 5.81 in., tf = 0.510 in., and tw = 0.300 in.

(a) Calculate the maximum shear stress τmax on cross section A-A located at distance d 2.5 ft from the end of the beam.

(b) Calculate the shear stress τ at point B on the cross section. Point B is located at a distance a 1.5 in. from the edge of the lower flange.

210_efd45e30-815e-4d9a-a6cb-073bf6f4e86b.png

Reference no: EM131062384

Questions Cloud

Competitive and evolving marketplace : How can an organization maintain a leadership position in a highly competitive and evolving marketplace? What does it take?
Benefit from a charitable relationship : How would you make sure you receive the most benefit from a charitable relationship?  Or, should this even be a consideration?  What do you think?
Consumer privacy on the internet : What concerns are there for consumer privacy on the Internet? Why is this such a prominent issue with consumer groups? What methods are available to mitigate these issues and how does it impact consumer behavior online?
Identify the symptoms of the organizational behavior problem : Identify the symptoms of the organizational behavior problem you have observed - discuss your rationale for choosing the concepts, theories, or research findings to explain the situation.
Calculate the maximum shear stress tmax on cross section : Calculate the maximum shear stress τmax on cross section A-A located at distance d 2.5 ft from the end of the beam.
Analyze the elements of the cause of action : Write a 700-to 1,050-word paper in which you include the following: Analyze the religious discrimination and accommodation issues presented in the video. Analyze the elements of the cause of action. Analyze the applicable defenses for the case
Which device permits packet switching : Which device permits packet switching so that a message can be routed to the next link in a network? In order to translate from an IP alias to an IP address, which of the following is used?
Problem regarding the product attributes : Write a detailed report to your boss listing some product attributes that may appeal to this subculture and recommend some marketin strategies
Which website does the best job of promoting their products : In your opinion, which website does the best job of promoting their products to the online purchaser? Why? Is the computer manufacturer that you selected, as being best at promoting their products, the same company you would buy from if you had to ..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  25 of the cables have failed after 12 years and 55 failed

25 of the cables have failed after 12 years and 55 failed after 16 years. if the distribution if normal what is the

  To what temperature would a constrained rod of aluminium

to what temperature would a constrained rod of aluminium with a diameter of 50 mm need to be heated if it is expected

  Consider a mixing chamber into which cold air enters

An air-conditioning system, streams of cold and warm air are mixed to get air with the right temperature. Consider a mixing chamber into which cold air enters at 8C and 100 kPa at a rate of 0.55 m^3 /s and warm air enters at 300C and 100 kPa. The rat..

  Sample of the ldpe

Paraphrase a Lab Report.The objective of this lab was to conduct a standard tensile test to determine the stress-strain behavior of a sample of the LDPE produced in the previous lab.

  What pressure is needed to isothermally compress ice

what pressure is needed to isothermally compress ice initially at -5c and 1 bar so that it changes phase? i dont even

  The turbine is located 75 m below the water surface if the

a river running at 500 m3s is collected in a reservoir behind a dam. the turbine is located 75 m below the water

  Fr v198 fts n2400 rpm and d 617 ft a show that j is a

the advance ratio j for a propeller is defined as jvnd where v is the velocity n is the propellers revolutions per

  If the atmosphere temperature is raised to 30degc what

a carnot refrigerator is maintaining foodstuffs in a refrigerated region at 2degc by rejecting heat to the atmosphere

  Volume of second tank and final equilibrium pressure of air

A 1-m tank contains air at 10oC and 350 kPa is connected through a valve to another tank containing 3 kg of air at 35oC and 200 kPa. Now the valve is opened, and the entire system is allowed to reach thermal equilibrium with the surroundings, which i..

  Find the power input to the compressor suppose on an actual

air flows through an adiabatic internally reversible compressor at a rate of 0.04 kgs. at the inlet thepressure is 200

  Provide an executive overview for infrastructure proposal

Executive Overview - Provide an executive overview for Infrastructure proposal. How will your proposal help EduTech? What are the key aspects of your design? Why should EduTech select your proposal over your competitors' proposals? (Half page) Des..

  Compare inlet steam mass and volume flow rates in pound mass

Compare the inlet steam mass and volume flow rates in pound mass per second and cubic feet per second of (a) a fossil-fuel power plant turbine having a polytropic efficiency of 0.90 and receiving steam at 2400 PSIA and 1000F and (b) a nuclear power p..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd