Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A beam of wide-flange shape, W 8 ×28, has the cross section shown in the figure. The dimensions are b = 6.54 in., h = 8.06 in., tw = 0.285 in., and tf = 0.465 in. The loads on the beam produce a shear force V = 7.5 k at the cross section under consideration.
(a) Using centerline dimensions, calculate the maximum shear stress σmax in the web of the beam.
(b) Using the more exact analysis of Section 5.10 in Chapter 5, calculate the maximum shear stress in the web of the beam and compare it with the stress obtained in part a.
1.an in-line six cylinder 6.6 liter four-stroke cycle si engine with multiple port fuel injection operates at 3000 rpm
10 kilogrms of steam is inside a piston-cylinder. the steam goes through an iso-thermal expansion from 500 kpa and 200
the 1.25 in diameter steel shaft bc is built into the rigid wall at c and supported by a smooth bearing at b. the lever
a continuous beam abc is fully restrained at point a and restrained at point c in all senses except that it may move in
a 0.5-in.-diameter steel e 30000 ksi bolt 1 is placed in a copper tube 2 as shown in fig. p5.47. the copper e 16000
Calculate the force exerted by the water in the pipe on the gate, and the distance GP between the centre of the gate, 0, and the centre of pressure P. Calculate the force exerted by the river water on the gate, and the distance GP
A high-speed elevator is being designed that must be able to travel at a maximum speed of 11.5 fts. You are asked to recommend the lift motor to use. The completely furnished carriage will have a mass of 3500 pounds. The design occupancy limit will b..
a lap joint is made by placing two 38in fillet welds across the full width of two 12in astm a36 steel plates. the
Using the iron-Carbon equilibrium phase diagram, please describe the lines of transformation to austenite during heating with carbon content
reinforced concrete highway pavement has a depth of 250 mm with 24 mm diameter steel rebars located 180 mm from the
Reheat, where high pressure and low pressure turbines are used, is added to a simple steam cycle to increase the steam quality at the location where the steam exits the low pressure turbine and goes to the condenser. Consider a steam cycle where the ..
If the final pressure is 1.0 MPa, determine (a) the temperature (°C) at the final state and (b) the heat transfer (kJ) during this process.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd