Calculate the maximum pressure kp and maximum temperature

Assignment Help Mechanical Engineering
Reference no: EM13633649

A six-cylinder, four-stroke internal combustion engine with compression ratio of 17 and displacement volume of 4.5 L is modeled using the ideal diesel cycle. Consider air in the cylinder is at 95 kPa and 57 degrees C at the start of compression. The engine operates at a speed of 2000 rpm. Heat input of 6.63 kJ occurs in every cycle. Consider variable specific heats for air.

(a) Calculate the maximum pressure (kP) and maximum temperature (degrees C) in the cycle.

(b) Determine the cut-off ratio of the cycle.

(c) Calculate thermal efficiency (%) of the cycle.

(d) Find the mean effective pressure (kPa) of the cycle.

(e) What is the total power output (kW) of the engine?

(f) Show the cycle on T-s diagram. Label states and show property values.

Reference no: EM13633649

Questions Cloud

Draw a diagram of the same problem above if the bullet : a 0.005 kg. bullet is fired at 300 ms east into a 10 kg. block of wood at rest. if the bullet sticks into the wood what
The radius of a solid sphere is measured to be 650-020 cm : the radius of a solid sphere is measured to be 6.50-0.20 cm and its mass is measured to be 1.85-0.02 kg. determine the
A researcher hypothesizes that people who listen to : a researcher hypothesizes that people who listen to classical music have higher concentration skills than those in the
A survey provided the estimate that the mean number of : a survey provided the estimate that the mean number of hours of television viewing per household is 7.25 hours per day.
Calculate the maximum pressure kp and maximum temperature : a six-cylinder four-stroke internal combustion engine with compression ratio of 17 and displacement volume of 4.5 l is
How much work is required to stop an electron m 911 : how much work is required to stop an electron m 9.11 multiplied by 10-31 kg which is moving with a speed of 1.72
A length sufficient to accelerate a 2mm diameter projectile : a linear motor is built utilizing neodymium permanent magnets supplying a magnetic field of .75t rails with an average
A bat can detect small objects such as an insect whose size : a bat can detect small objects such as an insect whose size is approximately equal to one wavelength of the sound the
The diameter of the bottle is 3 inches determine the : a bottle filled with soda rests on the conveyor of a grocery check-out. the bottle weights 2 lbs the cg is 8 inches

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Two dimensional steady state conduction occurs in a hollow

two dimensional steady state conduction occurs in a hollow cylindrical solid of thermal conductivity k 16wmk outer r -

  Detrmine a how far the package will slide on the horizontal

a 20-lb package is tossed by a postal worker onto a sloping chute at a with an initial velocity of 5 fts. knowing that

  The accerleration of a particle is defined by the relation

the accerleration of a particle is defined by the relation a a - 6t2 where a is constant. at t 0 the particle starts

  What is the atmospheric pressure at that altitude if the

a pilot flying a new airplane reports that she is flying at 49000 ft as read on her altimeter that is referenced to

  A round casting is 0 2 m in diameter and 1 m in length what

a round casting is 0. 2 m in diameter and 1 m in length. another casting of the same metal is elliptical in cross

  The other is moving upward at a constant velocity v2 if we

consider two-dimensionallaminar unidirectional flow between parallel spacing 2hvertical plates. one plate to the left

  Determine the change in specific entropy kjkg-k for air

1 initially an insulated rigid tank contains 2.85 kg of water at 263oc and 1 mpa. a heater in the wall of the tank

  At a given instant train e has a speed of 20ms and an

at a given instant train e has a speed of 20ms and an acceleration of 14ms2 acting in the direction shown 75 degrees to

  What gage material is used for a medium sized production

what gage material is used for a medium sized production for run? for higher-volume production? for situations

  Draw the block diagram of the uncontrolled seat

Draw the block diagram of the uncontrolled seat Plot the open loop displacement response of the uncontrolled seat to a step input

  A car drives over the top of a hill that has a radius of

a car drives over the top of a hill that has a radius of curvature of 100 ft. if the normal component of acceleration

  Find the work done if the pressure between the initial and

a system has an initial volume of 10 ft3 and expands to a final volume of 20 ft3. the initial pressure is 15 psia. find

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd