Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A computer simulation of a two-level system Quantum statistical mechanics: A spin in a magnetic field
Consider the same magnetic moment with spin-one-half in a magnetic field that we looked at in an earlier problem. The units of the magnetic field are again chosen such that the energy of the system is justE = -hσ
The system is in contact with a heat reservoir at temperature T. For this problem, instead of doing an analytic calculation, we will carry out a computer simulation using the Monte Carlo method. Although this might seem to be the hard way to do it, we will see later that the method can be generalized to solve problems that do not have analytic solutions.
1. Write a computer program to simulate this two-level system. The program should calculate the thermal probability of being in each state, as well as the average magnetization and the magnetic susceptibility. Have the program print out of the theoretical values for comparison.
2. Use your program to calculate the magnetization and magnetic susceptibility for a set of ‘interesting' values of the magnetic field and temperature.
a belt pulley is fastened to a 75 mm shaft running at 360 rpm by means of a key 18 mm wide and 125 mm long. the
the open water tank is resting on a frictionless plane. the capped orifice on the side has a 4-cm diameter exit pipe
What temperature will be indicated by the infrared imaging system as it is used to view the aluminum billet through a 6-mm-thick fused quartz window and what temperature will be indicated by the infrared imaging system when it is used to view the ..
Determining the Exit Temperature and Power Input of Air through a Compressor, Air at 150Pa and 310K enters a compressor of inlet diameter 2cm. The Compressor raises the pressure to 3.5 times the inlet pressure
An air standard dual cycle operates with a compression ratio of 15. At the beginning of the compression the conditions are 17°C, 0.95 bar, and 3.8L. The amount of heat added is 6.3 kJ, of which one-third is added at constant volume and the remainder ..
Problem: Find the stress, strain and displacement fields in elastic layer structure shown below.
the data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1000 k and 300 k
A 60-kg satellite travels in free flight along an elliptical orbit such that atA, whererA= 20 Mm, it has a speed vA= 40 Mm>h. What is the speed of the satellite when it reaches pointB, whererB= 80 Mm?Hint: See Prob. 14-82, whereMe= 5.976(1024) kg ..
Gas turbine engines are mostly seen in aircraft, while piston combustion engines are mostly seen in ground vehicles. Which advantages and disadvantages of these engines have caused them to be favorable for their respective applications?
If the voltage at the load is 100 V, find the maximum and minimum voltage on the line.
ocean temperature energy conversion otec power plants generate power by utilizing the naturally occurring decrease with
Calculate the specific removal rate and MRR (Volume of metal removed/sec) of Nickel in a certain electro chemical dissolution process, when a current of 500 A is being passed through the cell. Assume current efficiency = 100%.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd