Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Consider two very long, straight fins of uniform cross section, as shown in Figure 3.17. The rectangular fin has dimensions t = 1 mm and w = 20 mm. The circular pin fin has the same cross-sectional area as the rectangular fin. Both fins are constructed of aluminum with k = 237 W/m · K. In both cases, the base temperature is Tb = 85°C. Airflow is directed as shown in the figure, with T∞ = 20°C and u∞ = 5 m/s.
(a) Calculate the heat loss from each fin. Assume that the heat transfer coefficient on the edges of the rectangular fin is equal to the average value on the upper and lower surfaces.
(b) What diameter cylindrical fin would be needed to provide the same fin heat transfer rate as the rectangular cross-section fin?
a satellite is in earth orbit with an altitude at perigee of 555.0 km and an altitude at apogee of 1200.0 km. a. what
Define single shear? Define double shear? What is the equation for shear area? What is the equation for shear stress?
a 230-v shunt motor develops a torque of 40 ib-ft when the armature current is 11 a. find the torque developed when the
a solar-powered rankine cycle power plant uses 18.5 x 103 m2 of solar collectors. refrigerant-22 is used as the working
A 24-inch RCP outfall discharges directly onto the ground. The pipe has a slope of 1.75 percent and n-value of 0.015 and carries a design discharge of 20 cfs. Design a riprap apron for the outfall.
Metal balls 10 mm in diameter are to be annealed by heating them to 827°C then allowing them to cool slowly in air at 27°C to the point where they are in thermal equilibrium with the air. 2000 balls are annealed in one hour’s time. What is the total..
the overall volume compression ratio of a reversed carnot cycle working with air as a refrigerant is 10. the
a piston-cylinder device contains 5 kg of r134a at 800 kpa and 60 c. the refrigerant is now cooled at constant pressure
air is compressed in a piston-cylinder assembly from an initial pressure and temperature of 16 psi and 530 or to a
A mason stretches a string between two points 50 ft apart on the same level with a tension of 10 lb at each end. If the string weighs 0.1 lb, determine the sag h at the middle of the string.
Discuss typical material properties such as yield strength, ultimate strength, percent elongation, etc. What type of loading(s) (tensile, compression, torsion, combined) are the part subjected to during normal use
a pilot flying his ultralight aircraft at a speed of 60 mph. under standard atmospheric conditions what would be the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd