Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Calculate the electrical field strength between a pair of plates spaced 10 mm apart when a p.d. of 0.5 kV exists between them.
2. Two plates have a charge of 30 μC. If the effective area of the plates is 5 cm2, calculate the flux density.
Discuss the dependence of the number of propagating modes in a dielectric slab waveguide on the ratio of the thickness d of the dielectric slab to the wavelength
For the ladder network of given figure Find the current I.- Calculate the power delivered to R7, and compare it to the power delivered by the 240-V supply.
a. Functionally, how do closed-loop systems differ from open-loop system b. State one condition under which the error signal of a feedback control system would not be the difference between the input and the output.
The pole at fP1 = 104 is to be moved such that the feedback amplifier with a closed-loop low-frequency gain of 40 has a phase margin of 60 degrees. - Find the value of β.- Determine the new pole frequency.
design a two stage amplifier to meet the following specs undistorted outputat least 10vp-p bandwith from 20hz to
Determine the maximum and minimum values of the magnitude response. How many peaks occur in the magnitude response in the frequencyrange from zero to 2π What are the locations of the peak and dips
Without working out the numerical solution, determine which section would appear to have the most resistance. Explain.
A continuous-time signal x(t)=cos(2πt) is sampled every T seconds, resulting in a discrete-time signal x[n] = x(nT) . Determine whether the sampled signal is periodic and if the signal is periodic, determine the number of samples in the fundamenta..
Find the current in a ground loop that is 200 ft long, has a wire resistance of 0.05 ohms/ft, and has a difference of 4 V between grounds.
Determine input, output impedances, and voltage gain of the circuit, Zl, Zo, Av. Draw the small signal model of the circuit - what is the output signal amplitude?
1 To double the corner frequency in the low-pass and high pass two-pole filters, how would you change the values of the resistors and capacitors .2 Compare the one pole RC filters used in an active setup versus the passive setup
Calculate the reaction enthalpy and the Gibbs energy of water decomposition reaction at 25°, 1,000°, and 2,500°C and compare the results.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd