Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. A conductor, when placed at right angles to a magnetic field of density 700 mT, experiences a force of 20 mN, when carrying a current of 200 mA. Calculate the effective length of the conductor.
2. A conductor, 0.4 m long, lies between two pole pieces, with its length parallel to the pole faces. Determine the force exerted on the conductor, if it carries a current of 30 A, and the flux density is 0.25 T.
suppose station a and b are interconnected through two parallel unreliable links where each link has a failure
A certain transmission line is 10 meters long. Measurements indicate that the total inductance of the cable is 16 uH. Standing wave measurements indicate that the voltage reflection coefficient at the load is 0.5 + j0
a. Draw a block diagram of a closed-loop control system. b. Use the block diagram to describe how the system works. c. What is the advantage of this system over an open-loop system
Dissipations of Power in Lightbulbs, An incandescent lightbulb rated at 100 W will dissipate 100 W as heat and light when connected across a 110-V ideal voltage source
Point charges Q and are situated at (0, 0, 1) and (0, 0, ), respectively. Find the approximate electric field intensity at (a) (0, 0, l00), and (b) (100, 0, 0).
Why is it not possible to process signals with steps - e.g. sawtooth signals - correctly using digital processing?
find the transfer function and resolution for a 10-turn, 4.7k potentiometer with 3450 degrees of rotation and a 0 to 5 volt output. calculate the resolution in ohms per volt
To reduce confusion, the base can be denoted by a subscript. Hint: See the footnote on p. 248 in Section 7.4.
Determine the rms values of the voltages VR and VL and the current I. - Plot vR, vL, and i versus time on separate plots.
A group of technicians is gathered around a circuit that works with one signal generator but nit with the other. No one can figure out why one generator works but not the other. What might be happening.
Write an assembly language program to turn the stepper motor. Start a new project. Set bits 1 to 4 of PORT P ($25A) to 1 (output direction) Do not set bits 0, and 5-7, setting these bits may produce unexpected results.
1. What is the purpose of core in hollow solder wire 2. What is tinning, and why is it important 3. Why is safety so important when soldering 4. Why has lead-free solder replaced lead-based solder. Be sure to properly cite any sources of information.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd