Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
For a short transmission line having a series impedance Z=R+jXL, write the relationships between the sending-end and the receiving-end voltages and currents. Assuming a line with R=0, XL=20 ohm feeding a 1MW load at 0.95 power factor and at a voltage of 6.6kV, calculate the current flowing in the line and the sending-end voltage
Estimate the size and weight of an 1970 automobile using 1970 electronics technology which would have the equivalent computational power and electronics a typical 2013 automobile.
The amount of three phase power to be delivered in ‘kW' is equal to the total number of letters in your name (first name +last name) and the single phase power is 10% of three phase power. Assume same power factor for both types of loads.
f(t) = A[u(t) + u(-t/2-5)-1], where u(t) is the unit step function. Is the energy of this signal finite? Why or why not. If it exists, find the energy of this si
This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.
Surface integral for jet engine. The air-gas exhaust velocity from a jet engine varies linearly from a maximum of 300 m/s at the center of the circular exhaust opening to zero at the edges. If the exhaust diameter is 1.6 m, find thq exhaust flow.
I)Design a circuit that gives you the following relation between input and output Vout = 2.17Vin + 5 Here are the constraints you need to work with: 1) Only one power supply that gives ±12V is available 2) Available op-amps run on ±12V
A double-A (AA) rechargeable battery is rated at 1.2V, 2100mAh (mili-amp hours) 1- how many coulombs of charge can this battery hold 2- how many joules of energy are stored in the battery
The silicon cube you were shown consisted of 4x4x4 unit cells. You were shown one dopant in the silicon cube. Given that the lattice constant of silicon is 0.543 nm. Calculate the dopant density represented by the 4x4x4 silicon cube simulation.
Develop with MATLAB, a fuzzy control system for controlling the power of a motor (0-350 rpm) based on the supported load (0-1700 lbs) thereby that at greater load develops more power. The system must contain at least 5 rules, but preferably 7.
To maintain a freezer box at -40°C on a summer day when the ambient temperature is 27°C, heat is removed at the rate of 1.25 kW. What is the maximum possible coefficient of performance of the freezer
Assume the average energy density of sunlight to be 800 w/m^2 ---and the overall photovolatic system efficiency to be 10 percent. Calculate the land area covered with photovolatic cells needed to produce 1000 Mw , the size of a typical large centr..
a beam of polarized light of intesity I0 passes through a sheet of ideal polarizing material. The polarization axis of the beam and the transmission axis of the sheet differ by 30 degrees. What is the intensity of emerging light
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd