Calculate average emf induced in the high tension winding

Assignment Help Electrical Engineering
Reference no: EM131348333

The mutual inductance between the two windings of a car ignition coil is 5 H. Calculate the average emf induced in the high tension winding, when a current of 2.5 A, in the low tension winding, is reduced to zero in 1 ms. You may assume 100% flux linkage between the two windings.

Reference no: EM131348333

Questions Cloud

Tradeoff between inflation and unemployment : If I were the macroeconomic policy maker I would try to balance the short-run tradeoff between inflation and unemployment rate by doing a few things. First I would focus on maintaining and enforcing rules and regulations that help encourage compet..
Analysis of the definitions of social justice in the u.s. : Develop a 2-3-page analysis of the definitions of social justice in the U.S. and a country of your choice. Analyze the ideologies, identify their similarities, and explain how these factors support your statements or arguments about the social jus..
Determine the isentropic coefficient of performance : Determine the isentropic coefficient of performance of this system.- The coefficient of performance of a Carnot refrigerator operating between the same temperature limits.
Cross-price elasticity for product : Assume that the price of competing Good B decreases by 5% and as a result, the quantity demand for Good A decreases by 8%. What is the cross-price elasticity for your product? What type of goods are Good A and Good B?
Calculate average emf induced in the high tension winding : Calculate the average emf induced in the high tension winding, when a current of 2.5 A, in the low tension winding, is reduced to zero in 1 ms. You may assume 100% flux linkage between the two windings.
Income elasticity of demand for good a : Assume that the income of consumers changes by 10%, and as a result the quantity demanded for Good A changes by 8%. What is the income elasticity of demand for Good A? What does this mean for your company?
Are they are safety concerns associated with mergers : Airline Mergers. Why are they done typically? How the employees are affected? Are they're safety concerns associated with mergers?
The firm and the industry : In a competitive industry each firm has total costs C = q2 + 25. Demand increases from D0 =150 - 5p to D1 = 300 - 5p. Provide a pair of fully labeled diagrams showing "The Firm" and"The Industry" to outline the response to this increase in demand.
Determine isentropic coefficient of performance of system : Determine the isentropic coefficient of performance of this system.- The coefficient of performance of a Carnot refrigerator operating between the same temperature limits.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Compute power and the power factor for the total load

The load on a 460-v, 60-Hz, Y-connected, balanced three phase source consists of three equal Y connected impedance of 100-j100 Ohms and three equal delta-connected impedance of 300-j300 Ohms.

  Determine that a suitable sampling frequency is being used

Repeat the simulation using a sampling frequency of 10,000 Hz. What does this last simulation tell you? How can you determine that a suitable sampling frequency is being used?

  Explain the differences amonga truth table and state table

Explain the differences amonga truth table, a state table, a characteristic table, and an excitation table. Also, explain the differences among a Booleanequation, a state equation, a characteristic equation, and a flip-flop input equation.

  Determine what is the value of the smallest resistor

The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ohms, what is the value of the smallest resistor

  How big will be is impedence and resistance of the one bag

the power factor for delta-connected three-phase scheme is 0.6 .Consumed from the network with phase voltage 380 V current is (22+1.7) A.How big will be is impedence and resistance of the one bag

  What is the link between advertising and bonding

Advertising has been likened to offering a performance bond, where the seller must relinquish the bond if certain performance goals are not met. What is the link between advertising and bonding?

  Find the final speed of the puck b after the collision

Hockey puck B rests on a smooth ice surface and is struck by a second puck A, which has the same mass. Puck A is initially traveling at 14.6 and is deflected 28.0 from its initial direction. Assume that the collision is perfectly elastic.

  How long does battery take to be fully discharged

The battery capacity is 60 ampere-hours. The current drawn is 4 amps. How long does it take to be fully discharged

  Derive a state diagram for a finite state machine

Derive a state diagram for a Finite State Machine(FSM) that has an input w and an output z. The machine has to generate z = 1 when the privious four values of w were 1001 or 1111; otherwise, z = 0. Overlapping input patterns are allowed.

  Calculate the bandwidth and center frequency of amplifier

1. An amplifier has cutoff frequencies of 120.0 Hz and 1.200 kHz. Calculate the bandwidth and center frequency of the amplifier. 2. The upper cutoff frequency of an amplifier is 8.000 MHz and its center frequency is 1 MHz.

  Two identical conducting spheres a and b carry equal charge

Two identical conducting spheres A and B carry equal charge. They are separated by a distance much larger than their diameters.

  Convert the per unit generator reactance

a. Convert the per unit generator reactance to the step-up transformer base.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd