Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Describe how I/O ports are accessed in system that uses Memory-Mapped I/O and how they are accessed in a system that uses Direct I/O. List the advantages and disadvantages of each type ofport addressing.
Briefly describe some programming tasks where assembly language might be a good programming language choice.
Explain the relationship between the input and the output ac signals for a n-channel BJT voltage-divider bias. What components/parameters does the voltage gain depends on
A particular inverting amplifier with nominal gain of -100 V/V uses an imperfect op amp in conjunction with 100-k ohm and 10-M ohm resistors. The output voltage is found to be +9.31 V when measured with the input open and +9.09 V with the input gro..
Use PSPICE to generate the ideal current-voltage characteristics of a diode from a reverse-bias voltage of 5 V to a forward-bias current of 1 mA, for an IS parameter value of (a) 10 15 A and (b) 10 13 A. Use the default values for all other parame..
We have a load with an impedance given by Z=30+j40 ohms. The voltage across this load is V =1500sqrt(2)
1.)Using the SR0 instruction write the vbc1 assembly code that displays the One-Hot counter from left to right. 2.)Write the VBC1 assembly code that resembles the following behavior
If an ice cream cone is 6 inches tall and its rim has a diameter of 2 inches, determine the weight of ice cream that can fit in the cone assuming the ice cream above the cone is a perfect hemisphere.
The dielectric constant of LiF is 9.27 at low frequencies and approaches 1.9 at high frequencies. What are the percentage contributions of electronic and ionic polarization to the low-frequency polarization
If vid is 20-mV peak-to-peak sine wave applied in a balanced manner but superimposed on VCM = 0.5 V, what is the value that VDD must have to ensure saturation-mode operation for Q1 and Q2 at all times. Assume Vt = 0.5 V.
A gallium-arsenide crystal at 200K containing only donor impurities was found to have hole concentration to be one fifth that of the electron concentration. Determine the actual carrier concentrations and the doping concentration of the crystal.
1. How would you bias a BJT in a common emitter amplifier in order to minimize the Miller feedback capacitance 2. Explain how it is possible to identify the different current transport mechanisms.
Explain in one or two sentences the key reason why a CMOS Domino circuit is safer than an ordinary dynamic circuit when cascading several inseries
The nameplate on a 50-MVA, 60-Hz single-phase transformer indicates that it has a voltage rating of 8.0-kV: 78-kV. An open-circuit test is conducted from the low-voltage side, and the corresponding instrument readings are 8.0kV, 62.1A, and 206kW.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd