At what time has the energy stored in the inductor decreased

Assignment Help Electrical Engineering
Reference no: EM13268420

The magnitude of the current in a RL circuit decreases at a rate of 2000 A/s at t=0 and 100 A/s at t=.2s. At what time has the energy stored in the inductor decreased 1 percent of its intial value.

Reference no: EM13268420

Questions Cloud

Explain what percent recovery would you expect : If the solubility of compound A in there at 0 degrees C is 2.0 g/100 mL and at 35 degrees C is 40.0 g/100 mL, how much ether would you use to recrystallize 20 g of A. What percent recovery would you expect.
Find the thevenin equivalent voltage for the open-circuit : A somewhat discharged automotive battery has an open-circuit voltage of 12.5 V and supplies 50 A when a 0.1 Ohms resistance is connected across the battery terminals. A) Find theThevenin equivalent voltage for the circuit.
Purify the mixture of benzoic acid and biphenyl : If you had a mixture of benzoic acid (C6H5CO2H) and biphenyl (C6H5C6H5), how would you purify them based on solubility/recrystallization
Design a logic program that will track the activity : design a logic program that will track the activity for one turnstile. there will be three inputs PHASEA, B and RESET. there will be no output. the program should be able to track 999 total guests.
At what time has the energy stored in the inductor decreased : The magnitude of the current in a RL circuit decreases at a rate of 2000 A/s at t=0 and 100 A/s at t=.2s. At what time has the energy stored in the inductor decreased 1 percent of its intial value.
The proportion of sales less than $21,000 per month : The monthly average sales of the Smiling Ninja Computer Company may be approximated to a normal distribution curve. It has a mean of $22,000 and a standard deviation of $3,300.
Explain two reactions have the same activation energy : Two reactions have the same activation energy, but their rates at the same temperature differ by a factor of 10. Explain.
Determine numerical values for the turns ratio n3-n1 : The turns ratio (n3/n1) is chosen such that the converter produces the required output voltage at a transformer duty cycle of D=0.4. For each case determine numerical values for the turns ratio n3/n1 and for the efficiency.
What is the rate of heat loss by radiation from the stove : A black wood stove with surface area 4.6 m^2 is made from cast iron 4.0 mm thick. What is the rate of heat loss by radiation from the stove

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Is the energy of the signal finite and why

f(t) = A[u(t) + u(-t/2-5)-1], where u(t) is the unit step function. Is the energy of this signal finite? Why or why not. If it exists, find the energy of this si

  The condition on the sampling period is determined

Finding the periodicity in N of the discrete time signal x(n) = Cos(3pi*Ts.n + pi/4) and then plotting the discrete signal. From this the condition on the sampling period is determined

  What is the gain formula for a non inverting op amp

The LM358 op amp can be a single or dual supply op-amp. This mean that it can operate with just a single supply i.e. + 5 volt or with dual supplies i.e. (+ and -) 5 volt supplies. With a inverting configuration with dual supplies (+5v and -5v) bei..

  Design an up or down counter that has an input switch x

The counter should be designed using D flip-flops and using the state equation method. (No credit will be given if the circuit is designed using the excitation table method.) Draw the final logic diagram.

  What is simplified form of the minority carrier diffusion

An ideal n+/p diode has only the quasi neutral p region of length L illuminated with light such that GL electrons/cm3-s are generated uniformly throughout the region. There is no photo-generation occurring elsewhere in the diode. Derive the curren..

  Explain fundamental periods versus discrete time

A signal x[n] is formed by sampling a signal x(t) = -4sin(200*pi*t) at a sampling rate of 400Hz. Graph x[n] over 10 fundamental periods versus discrete time. Then do the same for the sampling frequencies of 60 and 200Hz.

  Derive minimal boolean expressions for circuit outputs

Design a 2-bit counter that, when f = 1, counts in the repeating sequence: 0, 2, 3, and when f = 0, counts in the reverse direction. Use T flip-flops. (a) Construct a state diagram or state table.

  Find when the triggering angle is greater than 140 degrees

The average voltage across the load when the triggering angle is 140 degrees. Keep in mind that the conduction is incomplete when the triggering angle is greater than 140 degrees.

  Consider a communications channel with a passband

Consider a communications channel with a passband of 3 kHz to 27.4 kHz. A modem will be connected to this communications channel and the modem will operate with a signaling rate that is 0.56 the maximum allowable signaling rate for this communicat..

  Explain a sinusoidal voltage has a maximum value

A sinusoidal voltage has a maximum value of 100V, and the value is 10V at t=0. The period is T=1ms. Determine the angular frequency, w, in rad/sec.

  Design preamplifier that has the characteristics mentioned

Design an EKG amplifier interface to a 6811/6812. The biopotential is a ±5-mV signal measured between the left and right arms using silver-silver chloride electrodes. A third electrode is placed in the right leg and is used as a reference.

  What is the measured period and frequency of the waveform

An oscilloscope shows the period of an ac waveform to be 3.5 horizontal divisions when the timebase control is set to "10 ms/Div". What is the measured period and frequency of the waveform

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd