Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Applied Loads, Young's modulus, Poisson's ratioThe Young's modulus and the Poisson's ratio for copper are 124.8 GPa and 0.36 respectively. When a tensile load is applie to a 1.5cm diameter copper rod, the diameter is reduced to 1.498cm. WHat is the correct applied load?
a) 81,640Nb) 73,500Nc) 82,550N
Entropy Generation in a Steam Turbine, Steam at a rate of 15lbm/s enters a turbine at 500 Psia, 800f and exits at 5 Psia. For a reversible, adiabatic process (iseentropic)
Compare the time and cost of using the following three alternative methods for casting the concrete for the wall: 1) direct chute 2) pumped 3) crane and bucket.
Effect of pressure on temperature and density of air for an adiabatic process, The pressure is to be raised from atmospheric to 7 psi (4.83 bar). The process is adiabatic, and the volume is constant and unknown.
Diffusion Coeffiecient, Calculate Constant, The diffusion coeffiecient for Cr^+3 in Cr2O3 is 6x10^-15 cm2/s at 727 degrees Celcius and is 1x10^-9 cm2/s at 1400 degrees Celcius.
Draw the Mohr's circle for this stress state, deterrnine the principal stresses and the angle of the principal direction to the x-axis and determine the maximum shear stress.
What is the discharge revised discharge pressure (guage pressure) of the compressor ? Is the assumption of change in temperature valid for calculating the discharge pressure of the compressor ?
Determine an expression for the number of cycles to failure, Nf if the initial crack size is a0. State any assumptions you make.
Prepare a power point presentation and a short report relating to the capabilities of Solidworks Motion Manager.
Horsepower and efficiency of three-phase motor, If a fully loaded 440V, three-phase motor draws 12.4 A at 86% power factor (pf). It's speed is 1730 rpm and its torque output to a mechanical load is 29.1 lb-ft x 1.356 = 39.5 Nm.
What is the discharge revised discharge pressure of the compressor.
All calculations and assumptions must be provided together with a full explanation of all the terms
A spur gear has 48 teeth with a diametral pitch of 8 and a pressure angle of 20 deg. The face width is 0.75 inches. If the gear is transmitting 25 HP at 250 rpm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd